Lexus SC300 / Lexus SC400. Service manual — part 933
CIRCUIT DESCRIPTION (Cont’d)
DIAGNOSIS CODE DETECTION DRIVING PATTERN
Purpose of the driving pattern.
(a) To simulate diag. code detecting condition after diag. code is recorded.
(b) To check that the malfunction is corrected when the repair is completed confirming that diag. code is no
longer detected.
Malfunction: Open or Short in Knock Sensor
Start engine and warm up.
After engine is warmed up, let it idle for 3 min.
With the A/C ON, perform quick racing (5,000 rpm) three times.
(Rapidly depress the accelerator pedal and suddenly release it.)
HINT:
If a malfunction exists, the ”CHECK” engine warning light will light up when sudden racing is
performed.
NOTICE:
If the conditions in this test are not strictly followed, detection of the malfunction will
not be possible.
–
ENGINE TROUBLESHOOTING
Circuit Inspection
TR–103
DIAGNOSTIC CHART
HINT:
If diag. code 52 is displayed, check No. 1 knock sensor (for left bank) circuit.
If diag. code 55 is displayed, check No. 2 knock sensor (for right bank) circuit.
If diag. code 53 is displayed, replace engine & ECT ECU.
Does malfunction disappear when a good knock
sensor is installed?
Repair or replace harness or
connector.
Replace knock sensor.
Check no continuity of knock sensor circuit.
Check knock sensor.
Check for open and short in harness and
connector between knock sensor and ECU.
Replace knock sensor.
Check and replace ECU.
WIRING DIAGRAM
TR–104
–
ENGINE TROUBLESHOOTING
Circuit Inspection
NG
OK
OK
NG
INSPECTION PROCEDURE
1
Check continuity between terminals KNK1, KNK2 of engine & ECT ECU connector and body
ground.
C
OK
P
(2) Connect the Check Harness A.
(See page
(2) Disconnect the engine & ECT ECU connector.
Measure resistance between terminals KNK1, KNK2 of
engine & ECT ECU connector and body ground.
Resistance:
1 M
or higher
Go to step 3.
2
Check knock sensor.
C
OK
P
Disconnect knock sensor connector.
Measure resistance between the knock sensor terminal
and body.
Resistance:
1 M
or higher
Replace knock sensor (See page
).
–
ENGINE TROUBLESHOOTING
Circuit Inspection
TR–105
OK
NG
NO
YES
3
Check for open and short in harness and connectors between engine & ECT ECU and knock
sensor (See page
Repair or replace harness or connector.
4
Does malfunction disappear when a good knock sensor is installed?
Replace knock sensor (See page
).
Check and replace engine & ECT ECU.
Reference | INSPECTION USING OSCILLOSCOPE
•
With the engine racing (4,000 rpm) measure
between terminals KNK1, KNK2 of engine & ECT
ECU and body ground.
HINT: The correct waveform appears as shown in the
Illustration on the left.
•
Spread the time on the horizontal axis, and confirm
that period of the wave is 151 sec.
(Normal mode vibration frequency of knock sensor:
6.6 KHz).
HINT: If normal mode vibration frequency is not 6.6 KHz, the
sensor is malfunctioning.
TR–106
–
ENGINE TROUBLESHOOTING
Circuit Inspection
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст