Lexus GS300/400 (2000 year). Service manual — part 2
N13790
Low Pressure
Service Valve
High Pressure
Service Valve
AC–12
–
AIR CONDITIONING
AIR CONDITIONING SYSTEM
2697
3.
INSTALL CHARGING CYLINDER
HINT:
When handling the charging cylinder, always follow the direc-
tions given in the instruction manual.
(a)
Charge the proper amount of refrigerant into the charging
cylinder.
(b)
Connect the center hose to the charging cylinder.
CAUTION:
Do not open both high and low hand valves of manifold
gauge set.
(c)
Open the valve of charging cylinder.
(d)
Press the valve core on the side of manifold gauge and
expel the air inside of the center hose.
A fully charged system is indicated by the sight glass being free
of any bubbles.
4.
SET OFF MANIFOLD GAUGE SET
(a)
Close both hand valves of manifold gauge set.
(b)
Disconnect the quick disconnect adapters from the ser-
vice valves.
5.
INSTALL CAPS TO SERVICE VALVES ON REFRIGER-
ANT LINES
AC0WA–01
I03811
Smog Ventilation
Sensor
No. 2 Cooling Fan Relay
(Marking: FAN NO.2)
No. 3 Cooling Fan Relay
(Marking: FAN NO.3)
Compressor
Magnetic Clutch Relay
(Marking A/C COMP)
Condenser
Ambient Temperature Sensor
Condenser Fan
Engine Coolant Temperature
(ECT) Switch
Air Inlet Servomotor
Blower Motor
Air Outlet Servomotor
A/C Amplifier
Evaporator
Solar Sensor
A/C Control Assembly
Electrical Multi Vision
(Built in A/C Control Assembly)
Expansion Valve
Air Refiner Filter
Blower Motor Control
Relay
Evaporator Temperature
Sensor
Heater Radiator
Air Mix Servomotor
(Driver Side)
Air Mix Servomotor
(Passenger Side)
Room Temperature
Sensor
–
AIR CONDITIONING
AIR CONDITIONING SYSTEM
AC–13
2698
LOCATION
CH0086
Correct
Wrong
AC0WB–01
I03853
GS 400:
A
B
P10652
GS 300:
Type A
Type B
A
B
A
B
AC–14
–
AIR CONDITIONING
DRIVE BELT
2699
DRIVE BELT
ON–VEHICLE INSPECTION
1.
INSPECT DRIVE BELT’S INSTALLATION CONDITION
Check that the drive belt fits properly in the ribbed grooves.
2.
INSPECT DRIVE BELT TENSION
Check that the arrow mark on the belt tensioner falls within area
”A” of the scale.
If it is out side area ”A”, replace the drive belt.
HINT:
When a new belt is installed, it should be lie within area B.
AC0WC–01
I03854
GS300:
Turn
I03855
GS400:
–
AIR CONDITIONING
DRIVE BELT
AC–15
2700
REMOVAL
1.
GS 300:
REMOVE DRIVE BELT
Loosen the drive belt tension by turning the drive belt tensioner
clockwise and remove the drive belt.
2.
GS 400:
REMOVE DRIVE BELT
Loosen the drive belt tension by turning the drive belt tensioner
counterclockwise and remove the drive belt.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст