Lexus RX300 (MCU15). Service manual — part 389
DI–786
–
DIAGNOSTICS
LEXUS NAVIGATION SYSTEM
LEXUS RX300 (RM785E)
19. No voice navigation.
INSPECTION PROCEDURE
1
Set the volume to the max in the menu screen.
OK
Normal. (Voice navigation is not available. No
destination is set, or the vehicle is running off
the route.)
NG
2
Check wire harness (navigation ECU and driver side door speaker).
PREPARATION:
Disconnect the navigation ECU connector and driver side door speaker connector.
CHECK:
(a)
Check continuity between terminal AUO+ of navigation ECU connector and terminal 1 of driver side
door speaker.
(b)
Check continuity between terminal AUO– of navigation ECU connector and terminal 2 of driver side
door speaker.
OK:
Continuity
NG
Replace or repair wire harness.
OK
3
Check the sound. (Check if the radio sound can be heard from the driver side
door speaker.)
OK
Replace the navigation ECU.
NG
Replace the speaker.
DI7PC–02
–
DIAGNOSTICS
LEXUS NAVIGATION SYSTEM
DI–787
LEXUS RX300 (RM785E)
20. Vehicle position rotates without control. (Map rotates without
control)
INSPECTION PROCEDURE
1
Recheck. (While not rotating the vehicle, turn the ignition switch ON from OFF
again.)
OK
Normal. (While the vehicle was turning, the igni-
tion switch was turned ON.)
NG
2
System check mode. (Is ”58–10” is displayed in the unit check mode of the navi-
gation ECU?)
Yes
Replace the navigation ECU.
No
3
System check mode. (Is ”58–43” is displayed in the unit check mode of the navi-
gation ECU?)
Yes
Replace and repair SPD terminal wire harness.
No
4
Navigation check mode (vehicle signal check mode: SPD and gyro).
OK
Replace the navigation ECU.
NG
DI7PD–02
DI–788
–
DIAGNOSTICS
LEXUS NAVIGATION SYSTEM
LEXUS RX300 (RM785E)
Replace or repair wire harness.
–
DIAGNOSTICS
LEXUS NAVIGATION SYSTEM
DI–789
LEXUS RX300 (RM785E)
21. Driving direction is opposite to moving direction of vehicle
position mark.
INSPECTION PROCEDURE
1
Navigation check mode (vehicle signal check mode REV).
OK
Replace the navigation ECU.
NG
2
Check the navigation ECU.
CHECK:
Check terminal REV.
OK:
REV: See ”Navigation ECU” of ”TERMINAL OF ECU”.
OK
Replace the navigation ECU.
NG
Replace or repair wire harness.
DI7PE–02
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст