Lexus RX300 (MCU15). Service manual — part 183
CO07U–02
–
COOLING
COOLANT
CO–1
LEXUS RX300 (RM785E)
COOLANT
INSPECTION
1.
CHECK ENGINE COOLANT LEVEL AT RADIATOR RESERVOIR
The engine coolant level should be between the ”LOW” and ”FULL” lines, when the engine is cold.
If low, check for leaks and add engine coolant up to the ”FULL” line.
2.
CHECK ENGINE COOLANT QUALITY
(a)
Remove the radiator cap from the radiator.
CAUTION:
To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator
are still hot, as fluid and steam can be blown out under pressure.
(b)
There should not be any excessive deposits of rust or scale around the radiator cap or radiator filler
hole, and the coolant should be free from oil.
If excessively dirty, clean the coolant passages and replace the coolant.
(c)
Reinstall the radiator cap.
B12248
Drain Plug
Drain Plug
CO07V–03
CO–2
–
COOLING
COOLANT
LEXUS RX300 (RM785E)
REPLACEMENT
1.
REMOVE ENGINE UNDER COVER
2.
DRAIN ENGINE COOLANT
(a)
Remove the radiator cap.
CAUTION:
To avoid the danger of being burned, do not remove the ra-
diator cap while the engine and radiator are still hot, as fluid
and steam can be blown out under pressure.
(b)
Loosen the radiator drain plug and engine drain plugs,
and drain the coolant.
(c)
Close the drain plugs.
Torque: 13 N·m (130 kgf·cm, 9 ft·lbf) for engine
3.
FILL ENGINE COOLANT
(a)
Slowly fill the system with coolant.
S
Use a good brand of ethylene–glycol base engine
coolant and mix it according to the manufacturer’s
directions.
S
Using coolant which includes more than 50 % ethyl-
ene–glycol (but not more than 70 %) is recom-
mended.
NOTICE:
S
Do not use an alcohol type coolant.
S
The coolant should be mixed with demineralized wa-
ter or distilled water.
Capacity:
9.0 liters (9.5 US qts, 7.9 lmp. qts)
(b)
Install the radiator cap.
(c)
Start the engine, and bleed the cooling system.
(d)
If necessary, refill coolant into the reservoir up to the
”FULL” line.
4.
CHECK ENGINE COOLANT FOR LEAKS
5.
REINSTALL ENGINE UNDER COVER
CO07W–03
B12311
N·m (kgf·cm, ft·lbf)
: Specified torque
LH Wiper Arm and Blade Assembly
Hood to Cowl Top Seal
Wiper Motor with Wiper Link
Outer Cowl Top Panel
x 6
Wiper Motor Connector
24 (245, 18)
RH Cowl Top
Ventilator Louver
LH Cowl Top Ventilator Louver
RH Wiper Arm and Blade Assembly
–
COOLING
WATER PUMP
CO–3
LEXUS RX300 (RM785E)
WATER PUMP
COMPONENTS
B12312
RH Fender Apron Seal
Generator Drive Belt
Engine Moving
Control Rod
No.2 RH Engine
Mounting Bracket
Ground Strap
PS Pump Drive Belt
64 (650, 47)
32 (320, 23)
N·m (kgf·cm, ft·lbf)
: Specified torque
Front Upper
Suspension Brace
80 (810, 59)
64 (650, 47)
80 (810, 59)
Master Cylinder Reservoir
Cruise Control Actuator
Cruise Control Actuator
Connector
CO–4
–
COOLING
WATER PUMP
LEXUS RX300 (RM785E)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст