Chrysler Voyager. Manual — part 511
TEST
ACTION
APPLICABILITY
2
Turn the ignition off to the lock position.
Flush the Transmission Oil Cooler and lines, replace the Transmission Oil Filter,
refill with new Transmission Fluid, start the engine, and adjust the fluid per the
Service Information.
Note: The Transmission Cooler must be flushed before prodceeding.
Allow the engine to idle for 10 minutes, in Park.
Turn the ignition off to the lock position.
Again, flush the Transmission Oil Cooler and lines, replace the Transmission Oil
Filter, refill with new Transmission Fluid, start the engine, and adjust the fluid per
the Service Information.
With the DRBIII
t, perform a Battery Disconnect.
NOTE: The Battery Disconnect must be done to re-enable EMCC during an
A/C Clutch engagement.
NOTE: The vehicle may exhibit intermittent shudder during the first few
hundred miles. The new Transmission Fluid will gradually penetrate the
Torque Convertor Clutch friction material and the shudder should disap-
pear.
Erase the DTC and return the vehicle to the customer.
Did the DTC reset and/or does the vehicle still shudder after a few thousand miles?
All
Yes
→ Replace the Torque Converter per the Service Information.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
No
→ Test Complete.
271
TRANSMISSION - NGC
P0897-WORN OUT/BURNT TRANSAXLE FLUID —
Continued
Symptom:
P0944-LOSS OF PRIME
When Monitored and Set Condition:
P0944-LOSS OF PRIME
When Monitored:
If the transmission is slipping in any forward gear and the pressure
switches are not indicating pressure, a loss of prime test is run.
Set Condition:
If the Transmission begins to slip in a forward gear and the pressure
switch(s) that should be closed are open, a loss of prime test begins. Available elements are
turned on by the PCM to see if pump prime exists. The DTC sets if no pressure switches
respond.
POSSIBLE CAUSES
SHIFT LEVER POSITION
PLUGGED TRANSMISSION OIL FILTER
TRANSMISSION OIL PUMP
INTERMITTENT WIRING AND CONNECTORS
TEST
ACTION
APPLICABILITY
1
NOTE: Low fluid level can be the cause of many transmission problems. If
the fluid level is low locate and repair the leak then check and adjust the
fluid level per the Service Information.
NOTE: Always perform diagnostics with a fully charged battery to avoid
false symptoms.
With the DRBIII
t, read Engine DTC’s. Check and repair all Engine DTC’s prior to
performing any transmission symptom diagnostics.
With the DRBIII
t, read Transmission DTC’s. Record all DTC’s and 1 Trip Failures.
NOTE: Diagnose 1 Trip Failures as a fully matured DTC.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors.
Repair as necessary.
Perform the Shift Lever Position Test. If the test does not pass, refer to Symptom test
for P0706 Check Shifter Signal.
For Gear Ratio DTC’s, check and record all CVI’s.
Most DTC’s set on start up but some must be set by driving the vehicle such that all
diagnostic monitors have run.
NOTE: Verify flash level of Powertrain Control Module. Some problems are
corrected by software upgrades to the Transmission and Engine software.
NOTE: Check for applicable TSB’s related to the problem.
Perform this procedure prior to Symptom diagnosis.
All
Continue
272
TRANSMISSION - NGC
TEST
ACTION
APPLICABILITY
2
Place the gear selector in park.
Start the engine.
NOTE: The TRANS TEMP DEG must be at least 43° C or 110° F before
performing the following steps.
The Transmission must be at operating temperature prior to checking pressure. A
cold Transmission will give higher readings.
Place the Transmission in Reverse.
With the DRBIII
t, observe the Transmission Pressure Switch states.
Are any of the Pressure Switches closed?
All
Yes
→ Go To 3
No
→ Go To 5
3
The conditions necessary to set this DTC are not present at this time.
Test drive the vehicle. Allow the Transmission to shift through all gears and ranges.
Did you experience a delayed engagement and/or a no drive condition?
All
Yes
→ Go To 5
No
→ Go To 4
4
The conditions necessary to set this DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wiring while checking for shorted and open circuits.
With the DRBIII
t, check the EATX EVENT DATA to help identify the conditions in
which the DTC was set.
Were there any problems found?
All
Yes
→ Repair as necessary.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
No
→ Test Complete.
5
With the DRBIII
t, perform a Shift Lever Position test. Follow the manuals on the
DRBIII
t.
Did the Shift Lever Position Test pass?
All
Yes
→ Go To 6
No
→ Refer to symptom list and perform test for DTC P0706.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
6
Remove and inspect the Transmission Oil Pan and Transmission Oil Filter per the
Service Information.
Does the Transmission Oil Pan contain excessive debris and/or is the Oil Filter
plugged?
All
Yes
→ Repair the cause of the plugged Transmission Oil Filter. Refer to
the Service Information for the proper repair procedure.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
No
→ Go To 7
273
TRANSMISSION - NGC
P0944-LOSS OF PRIME —
Continued
TEST
ACTION
APPLICABILITY
7
If there are no possible causes remaining, view repair.
All
Repair
Replace the Transmission Oil Pump per the Service Information.
Perform 41TE (NGC) TRANSMISSION VERIFICATION TEST -
VER 1.
274
TRANSMISSION - NGC
P0944-LOSS OF PRIME —
Continued
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст