Chrysler Voyager. Manual — part 482
TEST
ACTION
APPLICABILITY
5
Using the schematics as a guide, inspect the wiring and connectors. Repair as
necessary. Pay particular attention to all power and ground circuits.
If there are no possible causes remaining, view repair.
All
Repair
Replace and program the Powertrain Control Module per the
Service Information.
Perform POWERTRAIN VERIFICATION TEST VER - 2.
155
TRANSMISSION - EATX
*CHECKING PARK/NEUTRAL SWITCH OPERATION —
Continued
Symptom:
*INCORRECT TRANSMISSION FLUID LEVEL
POSSIBLE CAUSES
INCORRECT FLUID LEVEL
TEST
ACTION
APPLICABILITY
1
The transmission must be above 70 degree F. prior to checking fluid level. Adjusting
fluid level on a cold transmission will result in an overfilled transmission.
Check the transmission fluid level per the service information.
Is the fluid level OK?
All
Yes
→ Test Complete.
No
→ Adjust fluid level and inspect the Transmission and cooler lines
for any leaks and repair as necessary.
156
TRANSMISSION - EATX
Symptom:
*NO SPEEDOMETER OPERATION
POSSIBLE CAUSES
NO SPEEDOMETER OPERATION
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, under Transmission, check the pinion factor setting.
Is the pinion factor missing or set incorrectly?
All
Yes
→ One possible cause is the pinion factor is not set or is set
incorrectly in the TCM.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
No
→ Test Complete.
157
TRANSMISSION - EATX
Symptom:
*PRNDL FAULT CLEARING PROCEDURE
POSSIBLE CAUSES
PRNDL FAULT CLEARING PROCEDURE
.
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, erase Transmission DTCs.
Cycle the ignition off, then start the vehicle.
Firmly apply the brakes and shift into Overdrive.
NOTE: Vehicle must remain in Overdrive for at least 3.0 seconds.
With the brakes firmly applied, shift slowly through all gears (PRNDL) as least three
times, pausing momentarily in each gear.
NOTE: If all the PRNDL lights box individually then the error was cleared.
Shift into park and turn the ignition off to the lock position.
Ignition on, engine not running.
With the DRBIII
t, read Transmission DTCs.
Does the DTC P0706 reset, or do all the PRNDL indicators remain boxed in park or
neutral?
All
Yes
→ Return to the symptom list and perform diagnostics for P0706
CHECK SHIFTER SIGNAL.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
No
→ Test Complete.
Perform 41TE TRANSMISSION VERIFICATION TEST - VER 1.
158
TRANSMISSION - EATX
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст