Chrysler Voyager. Manual — part 329
Symptom:
NO BCM MESSAGES RECEIVED
POSSIBLE CAUSES
DTC PRESENT
NO RESPONSE - PCI BUS - BCM
CMTC/EVIC MODULE
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, erase DTCs.
Cycle the ignition and wait approximately 1 minute.
With the DRBIII
t, read DTCs.
Did this DTC reset?
All
Yes
→ Go To 2
No
→ The condition is not present at this time. Monitor DRBIIIt
parameters while wiggling the related wire harness. refer to any
Technical Service Bulletins (TSB) that may apply. Visually in-
spect the related wiring harness and connector terminals.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition on.
With the DRBIII
t, attempt to I/D or communicate with the BCM.
Was the DRBIII
t able to communicate with the BCM?
All
Yes
→ Replace the CMTC or EVIC in accordance with the Service
Information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Refer to the COMMUNICATION category and perform the appro-
priate symptom.
Perform BODY VERIFICATION TEST - VER 1.
743
OVERHEAD CONSOLE
Symptom:
NO FCM MESSAGES RECEIVED
POSSIBLE CAUSES
DTC PRESENT
NO RESPONSE - PCI BUS - FCM
CMTC/EVIC MODULE
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, erase DTCs.
Cycle the ignition and wait approximately 1 minute.
With the DRBIII
t, read DTCs.
Did this DTC reset?
All
Yes
→ Go To 2
No
→ The condition is not present at this time. Monitor DRBIIIt
parameters while wiggling the related wire harness. refer to any
Technical Service Bulletins (TSB) that may apply. Visually in-
spect the related wiring harness and connector terminals.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition on.
With the DRBIII
t, attempt to I/D or communicate with the FCM.
Was the DRBIII
t able to communicate with the FCM?
All
Yes
→ Replace the CMTC or EVIC in accordance with the Service
Information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Refer to the COMMUNICATION category and perform the appro-
priate symptom.
Perform BODY VERIFICATION TEST - VER 1.
744
OVERHEAD CONSOLE
Symptom:
NO PCM MESSAGES RECEIVED
POSSIBLE CAUSES
DTC PRESENT
NO RESPONSE - PCI BUS - PCM
CMTC/EVIC MODULE
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, erase DTCs.
Cycle the ignition and wait approximately 15 seconds.
With the DRBIII
t, read DTCs.
Did this DTC reset?
All
Yes
→ Go To 2
No
→ The condition is not present at this time. Monitor DRBIIIt
parameters while wiggling the related wire harness. Refer to any
Technical Service Bulletins (TSB) that may apply. Visually in-
spect the related wiring harness and connector terminals.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition on.
With the DRBIII
t, enter Body Computer, System Tests, then PCM Monitor.
Does the DRBIII
t display PCM Active on the Bus?
All
Yes
→ Replace the CMTC or EVIC in accordance with the Service
Information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Refer to the COMMUNICATION category and perform the appro-
priate symptom.
Perform BODY VERIFICATION TEST - VER 1.
745
OVERHEAD CONSOLE
Symptom:
NO TCM MESSAGES RECEIVED
POSSIBLE CAUSES
DTC PRESENT
NO RESPONSE - PCI BUS - TCM
CMTC/EVIC MODULE
TEST
ACTION
APPLICABILITY
1
With the DRBIII
t, erase DTCs.
Cycle the ignition and wait approximately 1 minute.
With the DRBIII
t, read DTCs.
Did this DTC reset?
All
Yes
→ Go To 2
No
→ The condition is not present at this time. Monitor DRBIIIt
parameters while wiggling the related wire harness. Refer to any
Technical Service Bulletins (TSB) that may apply. Visually in-
spect the related wiring harness and connector terminals.
Perform BODY VERIFICATION TEST - VER 1.
2
Turn the ignition on.
With the DRBIII
t, attempt to I/D or communicate with the TCM.
Was the DRBIII
t able to communicate with the TCM?
All
Yes
→ Replace the CMTC or EVIC in accordance with the Service
Information.
Perform BODY VERIFICATION TEST - VER 1.
No
→ Refer to the COMMUNICATION category and perform the appro-
priate symptom.
Perform BODY VERIFICATION TEST - VER 1.
746
OVERHEAD CONSOLE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст