Toyota FJ Cruiser (GSJ 10, 15 series). Manual — part 213
EXTERIOR – FENDER PANEL MUDGUARD
ET–81
ET
BODY
EXTERIOR
FENDER PANEL MUDGUARD
COMPONENTS
REAR BUMPER
COVER
x5
x2
N*m (kgf*cm, ft*lbf) : Specified torque
8.0 (80, 71 in.*lbf)
8.0 (80, 71 in.*lbf)
3.0 (30, 27 in.*lbf)
x2
WIRE to WIRE
CONNECTOR
WIRE to WIRE
CONNECTOR
B135139E01
ET–82
EXTERIOR – FENDER PANEL MUDGUARD
ET
x5
FRONT FENDER
MUDGUARD
QUARTER PANEL
MUDGUARD
x4
N*m (kgf*cm, ft*lbf) : Specified torque
5.0 (50, 44 in.*lbf)
5.0 (50, 44 in.*lbf)
B135081E01
EXTERIOR – FENDER PANEL MUDGUARD
ET–83
ET
REMOVAL
HINT:
The procedure described below is for the LH side. Use the
same procedure for both the RH and LH sides, unless
otherwise specified.
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL (w/ Back Sonar)
2.
REMOVE REAR BUMPER COVER (See page
3.
REMOVE FRONT FENDER MUDGUARD
(a) Using a clip remover, remove the clip.
(b) Remove the 5 screws and the front fender
mudguard.
4.
REMOVE QUARTER PANEL MUDGUARD
(a) Using a clip remover, remove the clip.
(b) Remove the 4 screws and the quarter panel
mudguard.
B135082
B135084
ET–84
EXTERIOR – FENDER PANEL MUDGUARD
ET
INSTALLATION
HINT:
The procedure described below is for the LH side. Use the
same procedure for both the RH and LH sides, unless
otherwise specified.
1.
INSTALL QUARTER PANEL MUDGUARD
(a) Align the 2 pins of the quarter panel mudguard with
the installation hole of the quarter outside moulding.
(b) Install the quarter panel mudguard with the 4
screws.
Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf)
(c) Install the clip.
2.
INSTALL FRONT FENDER MUDGUARD
(a) Align the pin of the front fender mudguard with the
installation hole of the front fender moulding.
(b) Install the front fender mudguard with the 5 screws.
Torque: 5.0 N*m (50 kgf*cm, 44 in.*lbf)
(c) Install the clip.
3.
INSTALL REAR BUMPER COVER (See page
)
4.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL (w/ Back Sonar)
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
B135085
B135083
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст