Ford Focus RS (2011 year). Manual — part 38
SECTION 501-12 Instrument Panel and Console
PAGE
CONTENTS
SPECIFICATIONS
501-12-2
Specifications
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..
REMOVAL AND INSTALLATION
501-12-3
Instrument Panel. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
501-12-11
Floor Console. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
501-12-13
Floor Console — Vehicles Built From: 03/2007, Vehicles With: Center Armrest. . . .
501-12-15
Overhead Console. . . . . . . . . . . . . . . . . . . . . . . . . . . ..
DISASSEMBLY AND ASSEMBLY
501-12-18
Floor Console
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
501-12-
Instrument Panel and Console
501-12-
1
.
VEHICLE APPLICATION:
Torque Specifications
lb-in
lb-ft
Nm
Item
71
-
8
Passenger airbag module retaining bolts
-
18
25
Steering column retaining bolts
G401861en
501-12-
2
Instrument Panel and Console
501-12-
2
SPECIFICATIONS
Instrument Panel
All vehicles
1. Remove the floor console. For additional
information,
refer to:
Floor Console
(501-12 Instrument Panel and
Console, Removal and Installation),
Floor Console - Vehicles Built From: 03/2007,
Vehicles With: Center Armrest
(501-12
Instrument Panel and Console, Removal
and Installation).
2. Remove the climate control assembly.
Vehicles built up to 04/2006
3. Remove the passenger air bag module.
Vehicles built 04/2006 onwards
WARNINGS:
The supplemental restraint system (SRS)
is active for a certain length of time after
the power supply has been disconnected.
Wait for a minimum of 3 minutes before
disconnecting or removing any SRS
components.
Wear safety goggles.
Do not probe supplemental restraint
system (SRS) electrical connectors.
4. Disconnect the battery ground cable.
For additional information,
refer to: Battery
Disconnect and Connect
(414-01 Battery,
Mounting and Cables, General Procedures).
5. Remove the central junction box (CJB) cover.
• Remove the retaining screws.
E51159
6. Detach the CJB from the in-vehicle
crossbeam.
• Rotate the retaining screws clockwise.
E100670
7. Disconnect the glove compartment cooling
hose from the glove compartment.
E87823
G388101en
501-12-
3
Instrument Panel and Console
501-12-
3
REMOVAL AND INSTALLATION
8. Remove the glove compartment.
E75829
x3
x7
9. Remove passenger air bag module support
bracket.
E75507
9 Nm
7 Nm
10. Disconnect passenger air bag module
electrical connector.
E75508
11. NOTE: The registers are retained by four
locking tangs. Releasing the upper locking
tangs will provide enough movement to
release the lower locking tangs.
Remove the passenger side inner register.
• Using a suitable thin bladed screwdriver,
release the upper locking tangs.
E50636
12. Remove the passenger air bag module
outer retaining bolts.
G388101en
501-12-
4
Instrument Panel and Console
501-12-
4
REMOVAL AND INSTALLATION
E123933
All vehicles
WARNING: When removing or installing
the instrument panel, care must be taken
not to scratch or damage the instrument
panel surface.
13. Remove the instrument cluster.
14. Remove the components in the order
indicated in the following illustration(s) and
table(s).
G388101en
501-12-
5
Instrument Panel and Console
501-12-
5
REMOVAL AND INSTALLATION
E53321
2
5
3
4
1
8
8
6
7
Description
Item
Instrument panel driver side lower panel
See Removal Detail
1
Headlamp switch
See Removal Detail
2
Instrument panel console switch panel
See Removal Detail
3
In-vehicle temperature sensor
See Removal Detail
4
Description
Item
Hazard flasher switch
See Removal Detail
5
Glove compartment lamp switch
See Removal Detail
6
Instrument panel passenger side outer
trim panel
7
Registers
See Removal Detail
8
G388101en
501-12-
6
Instrument Panel and Console
501-12-
6
REMOVAL AND INSTALLATION
E50898
9
11
10
Description
Item
Cigar lighter
See Removal Detail
9
Keyless entry antenna (if equipped)
See Removal Detail
10
Instrument panel
See Removal Detail
11
15. To install, reverse the removal procedure.
Removal Details
Item 1
Instrument panel driver side lower panel
1. Disconnect the data link connector (DLC).
E44539
Item 2
Headlamp switch
1. NOTE: Access to the headlamp switch is
from behind the instrument panel.
Remove the headlamp switch.
1. Release the retaining clips.
G388101en
501-12-
7
Instrument Panel and Console
501-12-
7
REMOVAL AND INSTALLATION
2. Disconnect the electrical connector.
E48095
1
1
2
Item 3
Instrument panel console switch panel
1. Disconnect the instrument panel console
switch panel electrical connectors.
E51980
Item 4
In-vehicle temperature sensor
1. Disconnect the in-vehicle temperature sensor
electrical connector.
E51912
2. NOTE: This step is only necessary if
installing a new instrument panel.
Remove the in-vehicle temperature sensor.
E50886
Item 5
Hazard flasher switch
1. Disconnect the hazard flasher switch
electrical connector.
E51874
2. NOTE: This step is only necessary if
installing a new instrument panel.
Remove the hazard flasher switch.
• Release the retaining clips.
E50885
G388101en
501-12-
8
Instrument Panel and Console
501-12-
8
REMOVAL AND INSTALLATION
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст