Ford E-250 (2006 year). Manual — part 13

Turning off speed control

There are two ways to turn off the
speed control:
• Depress the brake pedal. This will

not erase your vehicle’s
previously set speed.

• Press the speed control OFF

control.

Note: When you turn off the speed control or the ignition, your speed
control set speed memory is erased.

Driver Controls

53

KEYS
The key operates all locks on your vehicle. You should always carry a
second key with you in a safe place in case you require it in an
emergency.
Your keys are coded to your vehicle; using a non-coded key will not
permit your vehicle to start. If you lose your dealer supplied keys,
replacement keys are available through your authorized dealer.

POWER DOOR LOCKS (IF EQUIPPED)

Press U to unlock all doors and L to
lock all doors.

Memory lock
If you lock your doors with the power lock switch or the remote
transmitter while the sliding door is open, the door will automatically
lock after it is closed.

Back cargo door lock (if equipped)

The passenger side rear cargo door
has a power door lock control
mounted on the inside of the door.
When this lock is pressed, all doors
will lock/unlock.

REMOTE ENTRY SYSTEM (IF EQUIPPED)
This device complies with part 15 of the FCC rules and with RSS-210 of
Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may
cause undesired operation.

U

L

Locks and Security

54

Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
The typical operating range for your remote entry transmitter is
approximately 33 feet (10 meters). A decrease in operating range could
be caused by:
• weather conditions,

• nearby radio towers,

• structures around the vehicle, or

• other vehicles parked next to your vehicle.
The remote entry system allows you
to lock or unlock all vehicle doors
without a key. Note:
• The lock and unlock features

work when the ignition is in any
position.

• The panic feature is active when

the ignition is in either the 1
(ACCESSORY), 2 (LOCK) or 3
(OFF) positions.

If there are problems with the remote entry system, make sure to take
ALL remote entry transmitters with you to the authorized dealer in
order to aid in troubleshooting the problem.

Unlocking the doors

1. Press

and release to unlock the driver’s door. Note: The interior

lamps will illuminate.
2. Press

and release again within three seconds to unlock all the

doors.

Locking the doors

1. Press

and release to lock all the doors.

2. Press

and release again within three seconds to confirm that all

the doors are closed and locked. Note: The doors will lock again, and
the horn will chirp once.
Sounding a panic alarm
Press

to activate the alarm. Press the control again, or turn the

ignition to the 1 (ACCESSORY) or 4 (ON) position to deactivate the
alarm.

Locks and Security

55

Note: The panic alarm will only operate when the ignition is in the 2
(LOCK) or 3 (OFF) position.

Replacing the battery

The remote entry transmitter uses one coin type three-volt lithium
battery CR2032 or equivalent.

To replace the battery:

1. Twist a thin coin between the two
halves of the remote entry
transmitter near the key ring. DO
NOT TAKE THE RUBBER COVER
AND CIRCUIT BOARD OFF THE
FRONT HOUSING OF THE
REMOTE ENTRY TRANSMITTER.

2. Do not wipe off any grease on the
battery terminals on the back
surface of the circuit board.

3. Remove the old battery. Note: Please refer to local regulations when
disposing of transmitter batteries.

4. Insert the new battery. Refer to the diagram inside the remote entry
transmitter for the correct orientation of the battery. Press the battery
down to ensure that the battery is fully seated in the battery housing
cavity.

5. Snap the two halves back together.

Note: Replacement of the battery will not cause the remote transmitter
to become deprogrammed from your vehicle. The remote transmitter
should operate normally after battery replacement.

Locks and Security

56