Hyundai i30 / Elantra Neos. Body repair manual — part 25
BODY PANEL REPAIR PROCEDURE
BP-39
19. Remove the front side sill outer reinforcement section.
20. Measure and mark the vertical cutline on side sill inner
reinforcement as indicated in the illustration.
21. Cut the front side sill inner reinforcement along the
cutline.
17. Cut the front side sill outer reinforcement cutlines.
When cutting front side sill outer reinforcement, take
care not to cut through mating flanges.
18. Drill out all spotwelds, attaching the front side sill outer
reinforcement section.
NOTE
BEDBP6506B
BFDBP6507
BFDBP6507A
85mm
BEDBP6506C
BFDBP6507B
BP-40
BODY PANEL REPAIR PROCEDURE
22. Measure and mark the vertical cutlines on rear side
sill outer panel 55mm and 155mm from the rear door
step trim mounting hole.
23. Cut the rear side sill outer panel along the cutlines.
When cutting rear side sill outer panel, take care not
to cut through mating flanges or side sill outer
reinforcement.
24. Drill out all spotwelds attaching the rear side sill outer
panel section.
25. Remove the rear side sill outer panel.
26. Measure and mark the cutline on side sill outer
reinforcement as indicated in the illustration.
NOTE
BEDBP6508B
BEDBP6508C
BFDBP6508A
100mm
55mm
BFDBP6509
BFDBP6509A
105mm
BODY PANEL REPAIR PROCEDURE
BP-41
27. Cut the rear side sill outer reinforcement along the
cutline.
When cutting rear side sill outer reinforcement, take
care not to cut through mating flanges.
28. Drill out all spotwelds attaching the center pillar outer
panel.
BFDBP6509B
BFDBP6510
BFDBP6509C
NOTE
29. Remove the center pillar outer panel.
30. To remove the center pillar inner panel, drill out and
grind away all spotwelds and lap welds.
BEDBP6511
BEDBP6512
BEDBP6513
BP-42
BODY PANEL REPAIR PROCEDURE
31. Remove the center pillar inner panel.
32. Prepare all surfaces to be welded.
33. After removing, apply the welding primer.
BEDBP6514
BEDBP6514A
BEDBP6514B
INSTALLATION
1.
Fit and clamp the new center pillar inner panel in place
for welding.
2.
Measure each measurement point (Refer to the BODY
DIMENSIONS) and correct the installation position.
BEDBP6516
BEDBP6511A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст