Dacia Solenza (engine E7J). Service manual — part 135
81
INSIDE AND REAR LIGHTING
81 - 7
Lamps failures diagnostic
STOP LAMPS NOT WORKING
Check fuse F04 from cockpit fuse box.
Is it good?
Replace fuse F04
Yes
Yes
No
No
No
Yes
Replace the Stop contact
The stop contact wire supply is
broken or disconnected.
Fix it.
Bridge the Stop contact terminals.
Are the lamps working?
Is the Stop contact supplied ?
The stop contact wire supply is broken or
disconnected. Fix it.
INSIDE AND REAR LIGHTING
81
81 - 8
DISMOUNTING
Disconnect the (-) plug of the battery.
Pull the seat (1) of the access flap (2) to the fuse box located in the cockpit, at the left end of
the dashboard. Carefully remove flap (2).
Dismount the attaching screws (3) of the fuse box on the driving post crossbeam and detach
it from clips (4)
REMOUNTING
Attach in clips (4) the fuse box on the driving post crossbeam and mount the screws (3).
Carefully mount, the access flap (2) to the fuse box.
Connect the battery (-) terminal.
Perform functional tests, noticing the correct operation of all consumers supplied by means
of the cockpit fuse box.
OBSERVATION:
For vehicle equipped with programmable radio-tape player and electronic clock, af-
ter battery reconnecting, the radio code must be introduced and the clock re-programmed.
If COBRA 3800 or COBRA 3900 alarms have been mounted on the vehicle, in the
fuse box, may be found fuses F29 with value 15 A (mounted in seat (5)) and F 30 with
value 5A (mounted in seat (6)).
Cockpit fuse box
2
1
4
4
3
3
5
6
81
INSIDE AND REAR LIGHTING
81 - 9
Cockpit fuse box
The fuses are protecting the following electric circuits:
Fuse Symbol
Fuse
Protected circuit
number
type
F01
Free
F02
PLAF
15 A
Instrument panel, cockpit UCE(ceiling lamp operation, radio
F03
20 A
Cockpit UCE, air conditioning climate control panel *
F04
15 A
Cockpit UCE, diagnostic socket, airbag UCE, anti-starting
bushing
F05
UCE
10 A
UCE injection, petrol pump relay/ignition coil, instrument panel
INJECTION
F06
10 A
Windscreen wiper-washer switch (windscreen washing pump
operation), reverse driving switch, STOP switch, air
conditioning climate control panel*
F07
20 A
Windscreen wiper-washer switch, UCE cockpit (windscreen
wiper timer operation), windscreen wiper motor (stopping at fix point).
F08
7,5 A
Left meeting lights, instrument panel (indicator)
F09
7,5 A
Right meeting lights
F10
7,5 A
Left road lights, instrument panel (indicator)
F11
7,5 A
Right road lights
F12
15 A
Acoustic warning
F13
25 A
UCE cockpit (turning lights and hazard), diagnostic socket.
F14
7,5 A
Front/rear left parking lights, lighting: switches, climate control
panel, instrument panel, lighter, radio.
F15
7,5 A
Front/rear right parking lights
F16
15 A
Lighter, radio
F17
30 A
Climate control blower
F19
7,5 A
Fog lamp, instrument panel (indicator)
F20
25 A
Rear window defrosting
UCE
F21
INJECTION
5 A
UCE injection
F23
30 A
Right/left electric window regulator switch
F26
30 A
Air conditioning climate control blower*
F28
20 A
Fog projectors
* for vehicles equipped with air conditioning
INSIDE AND REAR LIGHTING
81
81 - 10
DESCRIPTION OF THE OPERATION
Dismount the battery (-) terminal;
Dismount the access flap to the cockpit fuse box;
Dismount the attachment screw of the UCE decoder and relays assembly.
Lift from its attachment place and remove UCE decoder and relays assembly.
UCE decoder protection
1
2
Carefully insert UCE decoder-relays assembly in the protector (1) so that protector is not
damaged.
Attach the protector to the front wiring by means of an attachment clip (2).
Mount the UCE decoder – relays assembly in the attachment place.
Mount the attachment screw of the UCE decoder and relays assembly.
Mount the access flap of the cockpit fuse box.
Connect the battery (-) terminal.
ATTENTION!
At any intervention implying dismounting of the UCE decoder-relays assembly, the
protector and the attachment clip are to be replaced.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст