Dacia Solenza (engine E7J). Service manual — part 113
57
57 - 4
INSIDE ACCESSORIES
19
20
17
16
15
18
Remove the access cover of the fuse box.
Dismount the three attachment screws (14)
of the fuse box.
21
14
Remove the access cover to the fuse box.
Swing over the little caps from the dashboard
lower part and dismount the attachment screws
(15) on the driving post cross member.
Dismount :
- attachment screws (16) of the climate
maintenance panel on the lower part dashboard;
- attachment screw (17) of the lower part
dashboard on the vent-AC distributor (RACV);
- attachment screws (18) of the lower part
dashboard on the driving post cross member;
- upper attachment screws (19) of the
lower part dashboard on the driving post cross
member.
Extract :
- headlamps adjustment knob;
- cigarette lighter.
Detach from clips the connectors:
- hazard;
- rear window defrosting.
Disconnect the connectors:
- cigarette lighter;
- rear window defrosting.
Dismount the attachment nut (21) of the
headlamps adjustment control.
Disconnect the connectors:
- hazard;
- climate maintenance control.
Detach from clips the left and right side
aeration ducts.
Take out the dashboard from cockpit.
Dashboard
57
57 - 5
INSIDE ACCESSORIES
REMOUNTING
Perform the dismounting operations in the reverse order, taking into consideration the follow-
ing recommendations:
- ensure that steering is at middle point (wheels are in a direct line);
- mounting of the lower part dashboard is to be performed by guiding it on a centering part
placed on the driving post cross beam;
- steering wheel must freely enter in grooves;
- check the operation of the dashboard instruments and switches.
ATTENTION :
After each steering wheel dismounting, its attachment screw is to be replaced, ob-
serving the required tightening moment of 4.4 daNm.
Dashboard
57
57 - 6
INSIDE ACCESSORIES
Dashboard
Airbag
Important!
Before reconnecting the driver’s airbag connector, it is necessary to apply a checking
procedure of the system:
- Check if airbag indicator from the instrument panel is on, when the contact is set
on.
- Connect the igniter to the airbag connector (to the wiring) and check if the airbag
indicator is off.
- Set the contact off, connect the airbag connector instead of the inert igniter and
attach the airbag on the steering wheel (requiret tightening moment is 0.65 daNm).
After remounting, perform the system checking by means of the CLIP tester.
If everything is correct, unblock the UCE airbag (see chapter 88 “Unblocking UCE
airbag”).
If is not correct, see chapter “Diagnostic”.
- Check if the airbag indicator from the instrument panel is on for 3 seconds from
setting the contact on, then it is off and is remaining off.
ATTENTION!
Non-observing of prevision prescriptions may cause un abnormal operation of the
system, leading to the airbag undesirable starting.
57
57 - 7
INSIDE ACCESSORIES
DISMOUNTING
Upper attachment:
By means of a screwdriver, detach from clips the limiting wire for documents compartment
door’s opening from lower part dashboard.
Lower attachment:
Push the plastic pin to the right side of driving post (in the arrow direction) and release the
documents compartment door from the lower part dashboard.
REMOUNTING
Perform the dismounting operations in the reverse order.
Documents compartment door
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст