Dacia Solenza (engine E7J). Service manual — part 114
57
57 - 8
INSIDE ACCESSORIES
Inside rear view mirror
DISMOUNTING
Dismounting of the interior rear view mirror (1) is to be performed by its depressing from the
support (2) in the direction of the arrow shown in the drawing.
The rear view mirror support (2) is stacked on windshield (3).
REMOUNTING
Perform the dismounting operations in the reverse order.
57
57 - 9
INSIDE ACCESSORIES
Sun visors
DISMOUNTING
Dismount the sun visor (2) attachment screw (1).
Extract the sun visor from the hook (3).
REMOUNTING
Perform the dismounting operations in the reverse order.
57
57 - 10
INSIDE ACCESSORIES
Central console
DISMOUNTING
Disconnect the battery.
Extract the ashtray (1) from its place.
Remove the gearbox lever covering (2) from
the central console.
Dismount:
- attachment screw (3) of the central
console on the tunnel;
- attachment screw (4) of the central
console on the gearbox lever support.
Detach the central console from the climate
maintenance- ventilating distributor clips
(RACV) from points (5).
Swing over the diagnostic socket cap and
push inside the console.
Disconnect the window lifting switch
connector (for vehicles equipped with electric
windows).
Detach from clips the window-lifting switch
and release the central console.
REMOUNTING
Perform the dismounting operations in the
reverse order.
Check the correct operation of the
switches of the front electric windows.
57
57 - 11
INSIDE ACCESSORIES
Handbrake case
DISMOUNTING
Through the cutting out existent in the cock-
pit carpet in the handbrake lever, dismount the
attachment screw (1) of the handbrake case in
front part, on the tunnel.
Move towards front the seats.
Dismount:
- bench seat (see chapter 75);
- attachment screws of the front safety belts
at lower part;
- attachment screws of the locks on the tun-
nel;
Detach from clips the carpet and roll it towards
front part.
Dismount the attachment screw (2) of the
handbrake case on the tunnel, in the rear part.
Release the handbrake case.
REMOUNTING
Perform the dismounting operations in the re-
verse order.
The safety belts screws are to be tighten to the
required moment of 2,7 daNm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст