Dacia Solenza (engine E7J). Service manual — part 5
VALUES AND ADJUSTMENTS
07
07 - 4
Accessories belts tension
Belts tensioning values are:
- alternator belt
253 – 273 Hz
- compressor belt
150 – 155 Hz
- power steering pumps belt
151 – 161 Hz
- compressor belt / DA pump
222 ± 8 Hz
Accessories belt tensioning method.
Belt tensioning is to be performed with cold engine.
Mount the new belt.
Tighten the belt till obtaining the prescribed mounting tensioning.
Block the tensioner.
Perform three engine crankshaft rotations.
Place the reading head of the MOT 1505 device in the measurement area and check if the
belt tensioning is within the mounting prescribed values; restore is necessary.
REMARK :
Once a belt is dismounted, is not to be remounted, but replaced.
A – crankshaft C – Compressor T – Tensioner pulley.
B – alternator D – Power steering pump – Tensioning checking point.
B
A
A
D
T
A
C
T
T
VALUES AND ADJUSTMENTS
07
07 - 5
Wheels, Tires
Vehicle
SOLENZA
Wheels
5.5J144 CH43
5.5B134CH46
Tires
165 / 65R14
165 / 70R13
Inflating pressure (bars) (1)
Front
Rear
Empty/Loaded Empty/Loaded
2.0/2.2
2.0/2.1
2.0/2.2
2.0/2.1
(1) Maximum loaded, wheels on the ground.
- tightening moment of the wheels screws : 7.5 daNm;
- wheel axial run out : maximum 1 mm;
- wheel radial rubout : maximum 1 mm.
The increase of tire temperature during driving implies a growth of the tire pressure with
0.2 – 0.3 bars compared with the prescribed values.
In case of tires pressure checking immediately after vehicle driving, consider this growth of
pressure.
VALUES AND ADJUSTMENTS
07
07 - 6
Brakes
Vehicle
Normal
20
Minim
19
Normal
228
Minim
229
Front
0.04
Rear
-
Brake disk width and drums diameter (mm)
Front
Rear
Maxim disk
axial run out
Vehicle
Normal
14
Minim
7
Normal
5
Minim
0.5 mm
above the
rivets
SAE J 1703 DOT 4
Gaskets thickness (mm)
Front
Rear
Brake fluid
SOLENZA
SOLENZA
VALUES AND ADJUSTMENTS
07
07 - 7
Dimensions under carriage body
DIMENSIONS UNDER CARRIAGE BODY CONDITIONING
ADJUSTMENT OPERATIONS OF THE STEERING ANGLES
H1, H4 - to be measured in front wheel axle, consequently rear wheel axle.
H2 - to be measured between the lower side of the power train support.
H5 – to be measured between the elastic joint axle of the rear axle arm and the ground.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст