Renault Kangoo (2018 year). Manual — part 15
5.39
On the road
POSSIBLE CAUSES
WHAT TO DO
Vibrations.
Tyres not inflated to the correct pres-
sure, incorrectly balanced or dam-
aged.
Check the tyre pressures: if this is not the
problem, have them checked by an ap-
proved Dealer.
Coolant boiling in the coolant reservoir.
Mechanical fault: damaged cylinder
head gasket.
Stop the engine.
Contact an approved Dealer.
Smoke under the bonnet.
Short circuit or cooling system leak.
Stop, switch off the ignition, stand away
from the vehicle and contact an approved
dealer.
The oil pressure warning light comes
on:
while cornering or braking
The level is too low.
Top up the engine oil level (refer to the in-
formation on “Engine oil level: topping up/
filling” in Section 4).
is slow to go out or remains lit under
acceleration
Loss of oil pressure.
Stop the vehicle and contact an approved
Dealer.
OPERATING FAULTS
(3/6)
5.40
On the road
POSSIBLE CAUSES
WHAT TO DO
Steering becomes heavy.
Assistance overheating.
Fault with the electric assistance
motor.
Fault in the assistance system.
Drive carefully at reduced speed, be aware
of the level of force in the steering wheel
needed to turn the wheels. Consult an ap-
proved dealer
The engine overheats. The coolant
temperature indicator and the warn-
ing light
®
come on.
Engine cooling fan not working.
Stop the vehicle, switch off the engine and
contact an approved Dealer.
Coolant leaks.
Check the coolant reservoir: it should con-
tain fluid. If there is no coolant, consult an
approved Dealer as soon as possible.
OPERATING FAULTS
(4/6)
Radiator: If there is a lack of coolant, remember that it must never be topped up using cold coolant while the engine is
very warm. After any procedure on the vehicle which has involved even partial draining of the cooling system, it must
be refilled with a new mixture prepared in the correct proportions. Reminder: only products approved by our Technical
Department may be used for this purpose.
5.41
OPERATING FAULTS
(5/6)
Electrical equipment
POSSIBLE CAUSES
WHAT TO DO
The wipers do not work.
Wiper blades stuck.
Free the blades before using the wipers.
Faulty electrical circuit.
Consult an approved dealer.
Fuse damaged.
Replace the fuse or have it replaced; refer
to the information on “Fuses” in section 5.
The wiper does not stop.
Faulty electrical controls.
Consult an approved dealer.
Direction indicators flashing more
quickly.
Blown bulb.
See information on “Headlights: changing
bulbs” or “Rear and side lights: changing
bulbs”.
The direction indicators do not work.
Faulty electrical circuit or control.
Consult an approved dealer.
Fuse damaged.
Replace the fuse or have it replaced; refer
to the information on “Fuses” in section 5.
The lights do not come on or go off.
Faulty electrical circuit or control.
Consult an approved dealer.
Fuse damaged.
Replace the fuse or have it replaced; refer
to the information on “Fuses” in section 5.
5.42
Electrical equipment
POSSIBLE CAUSES
WHAT TO DO
Traces of condensation in the lights
and headlights.
Traces of condensation may be a nat-
ural phenomenon caused by varia-
tions in temperature and humidity.
In this case, the traces will disappear
slowly once the lights are switched
on.
The front seat belt reminder light
comes on when the seat belts are
fastened.
An object is stuck between the floor
and the seat and is disrupting the op-
eration of the sensor.
Remove all objects from underneath the
front seats.
OPERATING FAULTS
(6/6)
6.1
Section 6: Technical specifications
Vehicle identification plates . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.2
Engine identification plates . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.3
Engine specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.4
Weights (in kg) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.6
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.7
Replacement parts and repairs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
6.9
Service sheets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.10
Anticorrosion check . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6.16
6.2
VEHICLE IDENTIFICATION PLATES
A
B
The information shown on the ve-
hicle identification plate should be
quoted on all correspondence or
orders.
The presence and location of the in-
formation depends on the vehicle.
Vehicle identification plate A
1 Manufacturer name.
2 EC design number or approval
number.
3 Identification number.
Depending on the vehicle, this
information is also given on
marking B.
4 MAM (Maximum Authorised
Mass).
5 GTW (Gross train weight: vehicle
fully loaded, with trailer).
6 MPAW (Maximim Permissible
Weight) for front axle.
7 MPAW on rear axle.
8 Reserved for related or additional
entries.
9 Diesel exhaust emissions.
10 Paint reference (colour code).
A
9
7
8
10
5
1
2
3
4
6
6.3
Quote the details given on engine
plate C on all communication or
orders.
(Location varies depending on engine)
1 Engine type.
2 Engine suffix.
3 Engine number.
ENGINE IDENTIFICATION PLATES
C
C
C
C
1
2
3
6.4
ENGINE SPECIFICATIONS
(1/2)
Versions
1.2 TCe
1.6 16V
1.5 dCi
Engine type
(see engine plate)
H5F Turbo
K4M
K9K
Cubic capacity (cc)
1 197
1 598
1461
Type of fuel
Octane rating
Petrol
It is essential that you use unleaded petrol of
the octane rating stated on the label inside the
fuel filler flap.
Refer to «Fuel tank» in Section 1.
Diesel
The label located in the fuel filler flap indicates
the authorised fuels.
Fuel types that meet
European standards and are
compatible with the engines
of vehicles sold in Europe
(in any other case, contact an
Approved Dealer).
Unleaded petrol compliant with
standard EN 228 contains up to
5 % ethanol in volume.
Diesel fuel compliant with
standard EN 590 contains up
to 7 % fatty acid methyl ester in
volume.
Unleaded petrol compliant with
standard EN 228 contains up to
10 % ethanol in volume.
Diesel fuel compliant with
standard EN 16734 contains up
to 10 % fatty acid methyl ester in
volume.
6.5
ENGINE SPECIFICATIONS
(2/2)
Versions
1.2 TCe
1.6 16V
1.5 dCi
Engine type
(see engine plate)
H5F Turbo
K4M
K9K
Cubic capacity (cc)
1 197
1 598
1461
Spark plugs
Only use the spark plugs specified for your vehicle’s engine.
The type should be marked on a label affixed inside the engine
compartment. If it is not then contact an approved Dealer.
Fitting spark plugs other than those specified may damage the
engine.
–
6.6
The weights indicated are for a basic vehicle without options: they vary depending on the your vehicle’s equipment.
Contact an approved Dealer.
Maximum permissible all-up weight (MMAC)
Total train weight (MTR)
Van version
Estate version
Weights are indicated on the vehicle identification plate (refer to
the information on “Vehicle identification plates” in Section 6)
Braked Trailer Weight *
found by calculating: MTR - MMAC
Unbraked trailer weight *
610
695
Permissible nose weight *
75
Maximum permissible load on roof
100 (including the carrying device)
* Towing weight (Towing a caravan, boat, etc.)
Towing is prohibited when the GTW - MAM calculation is equal to zero, or when the GTW is equal to zero (or is not listed) on the
identification plate.
– It is important to respect local towing regulations in force, specifically those set out in the Highway Code. Please contact your
authorised dealer about adapting any towing equipment.
– When towing, under no circumstances may the total train weight (vehicle + trailer) be exceeded. However the following is
permitted:
– the Maximum permissible weight at the rear may be exceeded by no more than 15%,
– the maximum permissible all-up weight may be exceeded by no more than 10% or 100 kg (whichever occurs first).
In either case, the maximum speed of the vehicle and trailer must not exceed 48 mph (80 km/h) (van versions) or 60 mph
(100 km/h) (estate versions) and the tyre pressure must be increased by 0.2 bar (3 PSI).
– The engine output and climbing capability are reduced with altitude. We recommend that the maximum load be reduced by 10%
at an altitude of 1,000 metres and by an additional 10% for each 1,000 metres thereafter.
Load transfer on Estate versions, average wheelbase
Depending on the local legislation, if the Maximum Authorised Mass of the vehicle has not been reached, up to 300 kg can be
transferred to the braked trailer, within the limits of the Gross Train Weight.
WEIGHTS (in kg)
6.7
DIMENSIONS (in metres)
(1/2)
H
B
D
A
C
F
G
E
6.8
DIMENSIONS (in metres)
(2/2)
Short
Medium
Long
A
0,9
B
2.3
2.7
3,1
C
0.7
D
3,9
4,3
4,7
E
2.1
F
1.5
G
1.5
H (unladen)
1.8
Turning circles between kerbs
9.6
10.7
11.9
Turning circles between walls
10.1
11.2
12.4
Important: if the vehicle is fitted with roof bars, the height must be increased by 0.070 m (the bars cannot be moved).
6.9
Original parts are based on strict specifications and are subject to highly-specialised tests. Therefore, they are of at least the same
level of quality as the parts fitted originally.
If you always fit genuine replacement parts to your vehicle, you will ensure that it performs well. Furthermore, repairs carried out
within the manufacturer’s Network using original parts are guaranteed according to the conditions set out on the reverse of the
repair order.
REPLACEMENT PARTS AND REPAIRS
6.10
Date: Miles (Km): Invoice number:
Comments/miscellaneous
Type of operation:
Stamp
Service □
. . . . . . . . . ... □
Anti-corrosion check:
OK □ Not
OK*
□
*See specific page
Date: Miles (Km): Invoice number:
Comments/miscellaneous
Type of operation:
Stamp
Service □
. . . . . . . . . ... □
Anti-corrosion check:
OK □ Not
OK*
□
*See specific page
Date: Miles (Km): Invoice number:
Comments/miscellaneous
Type of operation:
Stamp
Service □
. . . . . . . . . ... □
Anti-corrosion check:
OK □ Not
OK*
□
*See specific page
VIN: . . . . . . . . . . . . . . . . . . . . ..
SERVICE SHEETS
(1/6)
6.11
SERVICE SHEETS
(2/6)
VIN: . . . . . . . . . . . . . . . . . . . . ..
Date: Miles (Km): Invoice number:
Comments/miscellaneous
Type of operation:
Stamp
Service □
. . . . . . . . . ... □
Anti-corrosion check:
OK □ Not
OK*
□
*See specific page
Date: Miles (Km): Invoice number:
Comments/miscellaneous
Type of operation:
Stamp
Service □
. . . . . . . . . ... □
Anti-corrosion check:
OK □ Not
OK*
□
*See specific page
Date: Miles (Km): Invoice number:
Comments/miscellaneous
Type of operation:
Stamp
Service □
. . . . . . . . . ... □
Anti-corrosion check:
OK □ Not
OK*
□
*See specific page
6.12
SERVICE SHEETS
(3/6)
VIN: . . . . . . . . . . . . . . . . . . . . ..
Date: Miles (Km): Invoice number:
Comments/miscellaneous
Type of operation:
Stamp
Service □
. . . . . . . . . ... □
Anti-corrosion check:
OK □ Not
OK*
□
*See specific page
Date: Miles (Km): Invoice number:
Comments/miscellaneous
Type of operation:
Stamp
Service □
. . . . . . . . . ... □
Anti-corrosion check:
OK □ Not
OK*
□
*See specific page
Date: Miles (Km): Invoice number:
Comments/miscellaneous
Type of operation:
Stamp
Service □
. . . . . . . . . ... □
Anti-corrosion check:
OK □ Not
OK*
□
*See specific page
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст