Dacia SuperNova (engine E7J). Service manual — part 41
19 - 4
19
COOLING - EXHAUST - FUEL TANK
Components:
1.
Engine
2.
Radiator
3.
De-gassing pot
4.
Air-warming device
5.
Thermostat stand
6.
Nipple ø 3
7.
Draining screw
THE SCHEMA
Thermostat
Water pump
19 - 5
19
COOLING - EXHAUST - FUEL TANK
D
ISMONTING
The battery is disconnected.
The tubes of the radiator are stopped up with the MOT 453 devices.
Dismount the hoses from the radiator by means of the elastic collar pliers MOT 1202-01.
The two screws of the stand are taken off the upper traverse of the radiator and the radiator
is taken off.
The radiator is emptied and the cooling liquid is retrieved.
R
EMOUNTING
Check the existence of the supporting bushings.
The radiator is mounted.
The jacks for the fixing on the radiator are mounted, as well as the radiator stands, and the
fixing screws are fastened (0,57 daN).
The MOT 453 devices are taken off.
The tubes that have been taken off are mounted back and the collars are tightened.
Note : When mounting, line up the marks from the hoses and the related parts.
The battery is connected.
The filling and the draining of the cooling circuit is done.
Tightening moments:
- the screws for the radiator stands (M6- 2 pieces) - 0,57 daN.
RADIATOR
SPECIAL TOOLS
MOT 1202 - 01
Pliers for elastic collars
MOT 453
Tubes’ plug
19 - 6
19
COOLING - EXHAUST - FUEL TANK
COOLING FAN REPLACEMENT
for vehicles with air conditioning
1
6
5
3
2
4
7
8
DISMOUNTING
Disconnect the (-) plug of the battery.
Disconnect the cooling fan connector (5).
Disconnect the cooling fan resistance connector (1). Mark the mounting position iden-
tification of the two connectors.
Detach the wiring from clip (6).
Cut the clip attaching the wiring on the cooling fan assembly in point (7).
Dismount the four-attachement screws (3) of the cooling fan on the radiator, recovering the
washers (2) and (4).
Remove the cooling fan assembly.
REMOUNTING
Check the condition of the fan propeller, cooling fan electric motor, washers.
Tighten the attachement screw (3) of the assembly.
Replace the clip from point (7).
Mount the wiring of the cooling fan assembly taking into the consideration the mount-
ing position marked before dismounting. This is to be fixed by means of a clip in point (7)
and will pass trough the clip (6).
Connect the cooling fan resistance connector (1).
Connect the cooling fan connector (5). Observe the mounting position identification of
the two connectors.
Connect the battery plug (-). In case the vehicle is equipped with progammable radio-
cassettes, electronic clock, etc, these are to be reset before returning the vehicle to the client.
Check the cooling fan operation: start the vehicle engine and disconnect the water
temperature sensor. The cooling fan must start. Reconnect the water temperature sensor,
then by means of the CLIP tester, erase the memorized failure related to the water tem-
perature sensor.
FAILURES
ERASING
19 - 7
19
COOLING - EXHAUST - FUEL TANK
COOLING FAN DIAGNOSTIC
for vehicles with air conditioning
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст