Dacia Pick-Up 1304/1305/1307. Service manual — part 106
UPPER FRONT STRUCTURE
42
42 - 6
AERATION GRILL
D
ISMO UNTING
Dismount the two nozzles (1) of the wind-
screen washer.
Dismount the attachment screws (2) of the
aeration grill.
Take out the clips (3) from the front grill
grippers taking care to prevent their distortion
or damaging.
R
EMO UNTING
The mounting shall be done by performing
the dismounting operations in reverse order.
D
ISMO UNTING
Dismount the elements which are in
contact with the front pillar lining.
Detach the welding points of the front
pillar lining (1) which are in connection
with:
- front pillar in the area (4) and (5);
- floor closing plate in the area (8);
- windscreen lower cross bar in the
area (9);
- front wing lining upper edge in the
area (10);
- climate control box end in the area
(11);
- iron plate in the area (12).
Straighten the areas resulted by
dismounting.
Grind the areas resulted by dismounting.
R
EMO UNTING
Position and center the new element.
Check the correct positioning of the
front pillar lining.
Weld the front pillar lining (1) following
the assembling outliners 4,5,8,9,10,11,12.
Protect the new element with a corrosion
preventing and noise absorbent product.
43 - 1
43
UPPER SIDE STRUCTURE
FRONT PILLAR LINING
7
11
10
8
3
4
12
UPPER SIDE STRUCTURE
43
43 - 2
FRONT PILLAR
D
ISMO UNTING
Dismount the elements which are in contact with
the front pillar .
Detach the welding points of the front pillar (2)
which are in connection with :
- lateral frame in the areas (3);
- front pillar lining in area (4) and (5);
- upper spacer and the lower windscreen
lining in the areas (6), and (7).
Straighten the areas resulted by dismounting.
Grind the areas resulted by dismounting.
R
EMO UNTING
Position and center the new element .
Check the correct positioning of the front pillar.
Weld the front pillar (2) following the assembling
outliners 3, 4,5,6,7.
Protect the new element with a corrosion preventing
and noise absorbent product
9
6
5
43
UPPER SIDE STRUCTURE
43 -3
FRONT LOWER PANEL
D
ISMO UNTING
Dismount the elements which are in contact with
the front lower panel .
Detach the welding points of the front lower panel
(1) which are in connection with :
- floor closing plate in the area (2);
- front pillar in the (3) area;
- in the length of the area (4) with floor closing
plate;
- side panel in the area (5);
- central pillar in the area (6).
Straighten the areas resulted by dismounting.
Grind the areas resulted by dismounting.
R
EMO UNTING
Position and center the new element .
Check the correct positioning of the front lower
panel .
Weld the front lower panel (1) following the
assembling outliners 2, 3, 4,5,6.
Straighten with the autogenous welding the (3) area
with the front pillar, the (6) area with the central pillar
and the (5) area with side panel.
Leave open the water evacuation holes from the
front lower panel.
1
2
3
4
5
6
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст