SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 392
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
11
WHEELS & TIRE
STAVIC - 2004.09
4H
5. Pull out the lift plate from spare tire.
6. Put the lift plate into the center of the wheel when
installing.
7. Turn the handle clockwise until it sounds “click”.
8. Remove the handle and the wheel nut wrench.
[Notice]
•
Always keep the spare tire available.
•
When reinstalling the spare tire, securely fasten it.
•
If the lift plate is not in the center position or the spare tire
is not securely fastened, the spare tire may be out of position
during driving.
•
If a movement of spare tire is found, check the system and
reinstall in needed.
•
The wheel nut tightening surface of the spare tire should
be faced toward ground.
•
This device is desined only for manual operation. Never
use the impact type tool to remove the spare tire.
•
Store the flat and damaged tire in the trunk.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
12
WHEELS & TIRE
STAVIC - 2004.09
4H
6. MAINTENANCE AND REPLACEMENT
Separation
1. Fix the tire into the equipment and pull out the valve core
from the tire. Discharge the air inside the tire completely.
2. Tighten the locker in the center of the equipment to
assemble the rim to the equipment.
3. Remove the balance weight on the rim.
4. Separate the tire’s bead from the rim flange using the
approved lubricant.
[Notice]
Do not use silicone, synthetic detergent and gasoline, etc.
[Notice]
The assembly and disassembly of the tire is dangerous
working job. So, only the skillful worker must work this job
following the approved procedures.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
13
WHEELS & TIRE
STAVIC - 2004.09
4H
Maintenance
1. Check any damage the rim and replace as needed.
5. Apply the lubricant between the rim and the bead.
7. Pull out the opposite bead upward using the lever and
then separate the bead from the rim.
6. Insert the removal lever between the tire’s bead and the
rim and separate the rim from the tire.
[Notice]
Do not use the tool that may cause any damage such as pipe,
damaged bar.
[Notice]
•
Do not repair the rim as welding or soldering.
•
Replace the new valve as replaces new tire.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
14
WHEELS & TIRE
STAVIC - 2004.09
4H
Installation
1. Clean the rust, damaged rubber and dust, etc on the
rim’s surface with the brush.
5. Check any foreign material or liquid for the tire inside
and then install to push down the tire.
2. Install the rim to the equipment with the valve upward.
3. Tighten the locker in the center of the equipment to
assemble the rim to the equipment.
4. Apply the lubricant at the both bead portions and both
rim’s flange of the tire.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст