SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 391
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
7
WHEELS & TIRE
STAVIC - 2004.09
4H
Caster (+)
Caster 0
Caster (-)
Steering
axle
Center line
Front side
Steering
axle
Center line
Caster
Caster is the tilting of the uppermost point of the steering
axis either forward or backward from the vertical when
viewed from the side of the vehicle. A backward tilt is posi-
tive and a forward tilt negative. Caster influences direc-
tional control of the steering but does not affect tire wear.
Weak springs or overloading a vehicle will affect caster.
One wheel with more positive caster will pull toward the
center of the car. This condition will cause the car to move
or lean toward the side with the least amount of positive
caster. Caster is measures in degrees and is not
adjustable.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
8
WHEELS & TIRE
STAVIC - 2004.09
4H
1. Remove the wheel cap.
2. Support the vehicle with safety jack.
Loosen the wheel nuts and raise the vehicle carefully.
5. REMOVAL AND INSTALLATION
3. Remove the wheel nuts.
Tire
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
9
WHEELS & TIRE
STAVIC - 2004.09
4H
4. Install in the reverse order of removal.
[Notice]
•
Clean the mating surface of wheel and hub. Do not apply
grease or oil to bolts and nut. It may cause the looseness of
the fasteners.
•
Lift up the vehicle until the tire is off approx. 3 mm from
ground.
•
Tighten the wheel nuts by the order as shown in the figure
with several steps.
Tightening torque
Aluminum wheel: 120 ~ 130 Nm
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
10
WHEELS & TIRE
STAVIC - 2004.09
4H
1. Prepare the spare tire handle and wheel nut wrench.
2. Install the handle through the hole at the rear side of the
vehicle.
3. Connect the wheel nut wrench at the end of the handle.
Spare Tire
4. Turn the wheel nut wrench counterclockwise until the wire is loosened.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст