SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 355
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
27
TOD
STAVIC - 2004.09
4D
Function
Position A
Position B
Position C
Position D
Position ground
Control (4L - 4H)
Control (4H - 4H)
Pin
1
2
3
4
5
6
7
2(P/W)
5(Y/W)
7(P)
1(Br/W)
3(W)
6(Y)
4(V)
4. SHIFT MOTOR CONNECTOR
When selecting a position in 4WD switch (4H/4L), TOD control unit exactly changes the motor position to 4H and 4L by
detecting the electric signals from position encoder that monitors motor position.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
28
TOD
STAVIC - 2004.09
4D
2. Unscrew TCCU mounting nuts (M5-2EA)
REMOVAL AND INSTALLATION
1. TCCU
1. Move the driver’s seat to for front and open the seat cover.
3. Disconnect the TCCU connector and seperate the unit.
4. Install in the reverse order of removal.
[Notice]
Be careful not to apply any impact to TCCU body.
Installation Notice
Tightening torque
10 ± 1.0 Nm
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
29
TOD
STAVIC - 2004.09
4D
3. Disconnect the front and rear speed sensor connector (white, 7-pin) from bracket.
2. SHIFT MOTOR
1. Disconnect the negative battery cable.
2. Disconnect the shift motor/electronic magnetic clutch connector (black, 7-pin) and front and rear speed sensor
connector (white, 4-pin) at the rear top section of the transfer case.
4. Remove shift motor mounting bolts.
5. Remove bracket mounting bolt.
[Notice]
Remove two bolts for fixing the motor and bracket before
removing the shift motor and bracket.
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
30
TOD
STAVIC - 2004.09
4D
7. Clean the mating surface of the transfer case and shift
motor.
8. Apply sealant on the mating surface if new shift motor
assembly.
9. Install in the reverse order of removal. Make sure that
the mode switch selection is matched with the motor’s
driving position before installation.
6. Pull the shift motor assembly out while keeping the level.
[Notice]
Do not disassemble the shift motor since it is replaced as an
assembled unit.
[Notice]
To do that, install a new shift motor on the same location
that the used shift motor was on.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст