SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 271
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
6
2I
(Unit: mm)
When Using a Screen
1. Install a screen (2m X 1.5m) in front of the headlamps in vertical by 3m away and align the center lines of the vehicle
and the screen.
2. Run the engine with approx. 2,000 rpm and turn on the
headlamp. At this moment, the focus of the headlamp
should aim the “A” point.
3. If the focus deviates the “A” point, adjust the headlamp
aiming by rotating control levers (Up, Down, Left, Right)
in turn with a screwdriver.
(Unit: mm)
Center line of
vehicle
Vertical line of headlamp bulb
Horizontal line of
headlamp bulb
Horizontal line of headlamp
focus
Allowable focusing
area
Allowable focusing
area
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
7
2I
1
2
Fog lamp
Fog lamp
1 - Clockwise
Knob
Knob
2 - Counterclockwise
Knob
Up
Down
Fog Lamp Aiming Adjustment
1. Down
T h e l a m p a i m i n g m o v e s d o w n
when the knob is turned to direc-
tion 1 (clockwise).
2. Up
The lamp aiming moves up when
the knob is turned to direction 2
(counterclockwise).
To adjust the fog lamp downwards
To adjust the fog lamp upwards
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
8
2I
3. REMOVAL AND INSTALLATION OF EXTERIOR LAMPS
Locations of Exterior Lamps
3. Side turn signal lamp
Connector
Bulb
Lamp cover
2. Fog lamp assembly
Lamp cover
Bulb
Lamp cover
1. Headlamp assembly
4. High mounted stop lamp
7. Rear tail lamp assembly
5. License plate lamp
6. Tail lamp (back-up lamp)
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
9
2I
2. Remove one bolt in engine compartment, disconnect two connectors, and remove the lamp assembly.
1) Headlamp Assembly
Preceding work: Disconnection of negative battery cable
• The headlamp assembly consists of position lamp, headlamp low beam, headlamp high beam, and front turn signal lamp.
1. Remove two bolts on the lamp housing.
Cover rubber ring
3. Carefully remove the headlamp.
4. Install in the reverse order of removal.
[Notice]
If the cover rubber ring is worn, replace it with new one.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст