SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 270
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
2
2I
: one at each side (12V - 5W)
EXTERIOR LAMPS
1. LOCATIONS OF EXTERIOR LAMPS
Front Lamps
Headlamp
Headlamp
Fog lamp (LH)
Fog lamp (RH)
Tail lamp:
one at each side (12V - 5W)
Low beam:
one at each side (12V - 55W)
High beam:
one at each side (12V - 55W)
Turn signal lamp:
one at each side (12V - 28W)
Side turn signal lamp:
one at each side (12V - 5W)
Tail lamp
Turn signal lamp
Headlamp
(High beam)
Tail lamp/Turn signal lamp
connector
Connector
5
2
3
4
Headlamp
(Low beam)
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
3
2I
High mounted stop lamp
: center – 1 (12V – 5W)
Rear lamp
Tail lamp assembly
License plate lamp
: center – 2 (12V – 5W)
Stop lamp: one at each side (12V - 8W)
Rear turn signal lamp: one at each side (12V - 27W)
Tail lamp: one at each side (12V - 8W)
Tail lamp assembly
connector
Stop lamp
Rear turn signal lamp/Rear fog lamp
Tail lamp
Rear Lamps
Rear fog lamp
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
4
2I
Adjustment of low beam
No.1 adjustment hole: Up and Down
No.2 adjustment hole: Left and Right
Adjustment of high beam
No.3 adjustment hole: Up and Down
No.4 adjustment hole: Left and Right
2. AIMING AND ADJUSTMENT OF FRONT LAMP
Headlamp Aiming
An approved beam setting device should be used for a
correct headlamp aiming.
Make sure to follow the operating instructions provided by
the manufacturer.
If not available to use the beam setting device, adjust the
headlamp aiming with a screen.
Headlamp aiming requirements:
- parking on a flat surface
- specified tire pressure
- one passenger (driver, 65 kg),
- spare tire and OVM tools loaded (unlade all other loads)
No.1 adjustment:
Direction A - Up
Direction B - Down
No.2 adjustment:
Direction C - Left
Direction D - Right
No.3 adjustment:
Direction E - Up
Direction F - Down
No.4 adjustment:
Direction G - Left
Direction H - Right
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
LAMP
STAVIC - 2004.09
5
2I
Cautions During the Aiming
Procedures
The headlamp angle should be within the adjustment range
as shown in the figure.
When using a beam setting device
1. Align the vehicle and beam setting device according to the operating instructions provided by the manufacturer.
2. Adjust the headlamp aiming by rotating the direction control levers (Up, Down, Left, Right) in turn with a screwdriver.
Adjust the headlamp aiming by rotating the direction control
levers (Up, Down, Left, Right) in turn with a screwdriver.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст