SsangYong Stavic / SsangYong Rodius (2005 year). Service manual — part 29
1B-100
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
OIL PRESSURE RELIEF VALVE
Preceding Work: Removal of oil pan
1. Screw plug . . . . . . . . .. 50 Nm (37 lb-ft)
2. Compression spring
Removal & Installation Procedure
1. Remove the screw plug (1).
Installation Notice
2. Remove the spring (2), guide pin (3) and the piston (4).
3. Installation should follow the removal procedure in the
reverse order.
Notice
Don’t use the seal for the screw plug.
3. Guide pin
4. Piston
Tightening torque
50 Nm (37 lb-ft)
1B-101
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
OIL NON-RETURN VALVE
Preceding Work: Removal of timing gear case cover
1. Oil Non-return valve
Functions
The non-return valve prevents the oil in the chain
tensioner from drying up. In other words, it stops
oil-returning in order to prevent the oil in the chain
tensioner from getting dry. As a result, the chain
tensioner can be activated with oil in itself.
Replacement Procedure
1. Remove the non-return valve using a pliers.
2. Insert new non-return valve with hand.
1B-102
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
OIL DIPSTICK GUIDE TUBE
1. Oil dipstick level gauge
2. Oil dipstick guide tube
Removal & Installation Procedure
1. Pull out the oil dipstick level gauge (1).
2. Remove the bolt (4) in the upper intake manifold and
remove the oil dipstick guide tube.
Installation Notice
3. Install new O-ring to the dipstick guide tube.
4. Installation should follow the removal procedure in the
reverse order.
5. Check for leaks by starting the engine.
3. O-ring
4. Bolt (M6 x 12, 1 piece) 9 ~ 11 Nm (80 ~ 97 lb-in)
Tightening torque
9 ~ 11 Nm
(80 ~ 97 lb-in)
1B-103
CHANGED BY
EFFECTIVE DATE
AFFECTED VIN
ENGINE MECHANICAL
M162 GSL ENG SM - 2005.7
OIL GALLERY IN CRANKCASE
Preceding Work: Removal of crankshaft
Removal of oil spray nozzle
1. Plug
2. Steel ball
Cleaning Procedure
1. Remove the plug (1) with a screwdriver.
2. Using a round bar (3) and hammer, remove the steel ball
(2).
3. Using the compressed air, blow into the oil galleries and
clean it off.
3. Round bar . . . . . . . . . ..
φ 11 x 750 mm
UNIT REPAIR
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст