SsangYong Rexton. Service manual — part 629
SSANGYONG Y200
7B-18 GENERAL HVAC SYSTEM
REPLACEMENT OF REFRIGERANT
CONNECTION
1. When connecting a O-ring type, apply compressor
oil to portions shown in illustration. Be careful not
to apply oil to threaded portion.
Notice: Use the approval compressor oil.
2. O-rings must be closely attached to inflated
portion of pipe and always replace used O-rings.
3. After inserting the pipe to the union, tighten the
nut by hand as much as possible and tighten the
nut with the specified torque.
3. Measure the amount of the discharged oil. If the
the amount of the discharged oil is below 70 cc, it
means the oil leak. Check the connections of the
system and repair or replace as needed.
4. Check the oil contamination and add the oil or
adjust the oil level.
Notice: For contaminating the oil by the dust or
the foreign material, charge the refrigerant in the
system and clean the receiver-drier.
YAD7B260
YAD7B270
YAD7B280
YAD7B290
GENERAL HVAC SYSTEM 7B-19
SSANGYONG Y200
REPAIR INSTRUCTIONS
ON-VEHICLE SERVICE
AIR FILTER (AUTO A/C)
Removal & Installation Procedure
1. Remove the glove box.
2. Remove the lower bracket of crash pad.
3. Remove the air filter.
4. For replacing the air filter, verify that the flowing
direction mark of the air filter face toward the
evaporator core.
Notice: Installation should follow the removal
procedure in the reverse order.
YAD7B300
YAD7B310
YAD7B320
SSANGYONG Y200
7B-20 GENERAL HVAC SYSTEM
RECEIVER-DRIER
Removal & Installation Procedure
1. Discharge and recover the refrigerant from the
system.
2. Remove the head lamp assembly.
3. Disconnect refrigerant pressure sensor connector.
4. Remove the receiver-drier.
•
Remove two flange nuts.
•
Remove the O-ring
•
Remove the bracket bolt retaining the receiver-
drier and then remove the receiver-drier.
YAD7B340
YAD7B350
YAD7B360
YAD7B370
GENERAL HVAC SYSTEM 7B-21
SSANGYONG Y200
5. Installation should follow the removal procedure
in the reverse order.
•
Tighten the two flange nuts.
•
Evacuate and recharge the A/C system.
Notice: Before installing, check the O-ring and
apply the compressor oil.
CONDENSER
Removal & Installation Procedure
1. Discharge and recover the refrigerant from the
system.
2. Remove the radiator grill and front bumper.
3. Remove the inlet pipe.
Remove the O-ring at the same time.
4. Remove the outlet pipe (at the bottom side) with
O-ring.
YAD7B380
YAD7B390
YAD7B400
YAD7B410
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст