SsangYong Rexton. Service manual — part 364
SSANGYONG Y200
1B3-32 DIESEL ENGINE MECHANICAL
YAD1BBQ0
YAD1BBT0
YAD1BBR0
YAD1BBS0
16. Disconnect the blow by hose from the cylinder
head cover.
17. Disconnect the glow plug cables.
18. Remove the intake manifold (10) and gasket.
19. Remove the cylinder head cover and gasket.
DIESEL ENGINE MECHANICAL 1B3-33
SSANGYONG Y200
YAD1BBU0
YAD1BBV0
YAD1BBW0
YAD1BBX0
21. Disconnect the cables from the glow plug sensor
and engine coolant temperature sensor.
22. Remove the heater pipe bracket from the oil filter.
23. Pry off the clamp and push the heater feed pipe
forward and then pull out the pipe.
24. Disconnect the fuel lines from the fuel filter.
20. Remove the cable channel.
SSANGYONG Y200
1B3-34 DIESEL ENGINE MECHANICAL
YAD1BBY0
YAD1BBZ0
YAD1BC00
YAD1BC10
25. Disconnect the fuel lines from the injection pump.
27. Remove the fuel injection nozzle and nozzle
washer.
26. Remove the fuel filter.
28. Rotate the crankshaft and set the no.1 cylinder at
TDC.
Notice: Do not rotate the crankshaft to the
opposite direction of engine revolution.
DIESEL ENGINE MECHANICAL 1B3-35
SSANGYONG Y200
YAD1BC20
YAD1BC30
YAD1BC40
YAD1BC50
30. Ensure that the camshaft and the bearing cap
marking are aligned.
31. Remove the starter motor and install the engine
lock 602 589 00 40 00 onto the flywheel ring gear.
32. Remove the exhaust manifold and exhaust pipe.
29. Place alignment marks on the camshaft gear and
timing chain.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст