SsangYong Rexton. Service manual — part 618
SSANGYONG Y200
6E-8 STEERING COLUMN
ON-VEHICLE SERVICE
STEERING COLUMN
Removal
1. Disconnect the negative terminal of battery and
place the tires in front straight direction.
2. Untighten the fixing screw in the left/right of
steering wheel and remove the horn pad (airbag
module assembly) in the wheel.
At this time, remove the airbag module connector
simultaneously.
YAD6E080
YAD6E090
YAD6E070
3. Untighten the wheel fixing nuts and remove the
steering wheel using the special tool.
Notice:
•
When you remove the wheel, be sure to do
alignment mark in column shaft and wheel.
•
Remove the remote control switch connector
(airbag connector, horn connector)
4. Remove the fuel filler door release cable, hood
release cable, side mirror switch.
MAINTENANCE AND REPAIR
STEERING COLUMN 6E-9
SSANGYONG Y200
YAD6E120
YAD6E130
YAD6E110
6. Untighten the side fixing bolts/screws of instrument
panel and then remove the panel.
7. Ntighten the column fixing bolts from the steering
column shaft and then remove the upper/lower
column cover.
8. Disconnect the connector connected with the
combination switch and the fuel cut vacuum hose.
Notice: Be sure to check the fuel cut hose because
the identification color is marked.
YAD6E100
5. Remove the instrument panel side cover and
untighten the fixing bolts of inner fuse box.
SSANGYONG Y200
6E-10 STEERING COLUMN
10. Remove the combination switch assembly from
the column shaft which the airbag module is
separated.
YAD6E150
YAD6E160
YAD6E170
11. Mark the assembly marking on the column shaft
and lower shaft and then untighten the upper fixing
bolt of column shaft.
12. Untighten the housing floor fixing bolts of steering
column shaft.
YAD6E140
9. Remove the contact coil from the steering column
shaft.
STEERING COLUMN 6E-11
SSANGYONG Y200
B
A
1
2
STEERING WHEEL & SHAFT
Removal
1. Remove the upper bolt of lower shaft.
2. Remove the bolt of lower shaft and steering gear
box coupling and then remove the lower shaft
Notice: Mark the assembly marking.
YAD6E190
YAD6E200
YAD6E210
Tightening Torque
30 - 40 N•m
(22 - 30 lb-ft)
Installation
1. Insert the lower shaft into the gear box (spline part)
and then tighten the blots as specified torque.
Notice:
•
Install the lower shaft to tighten the bolt in non-
spline part of upper spline part
•
Install to align the assembly marking
Installation Notice
2. Install the steering column shaft in the lower shaft
to align the assembly marking and then tighten
the bolt.
Notice:
•
Install the lower shaft to tighten the bolt in non-
spline part of upper spline part
•
Install to align the assembly marking
Installation Notice
Tightening Torque
30 - 40 N•m
(22 - 30 lb-ft)
YAD6E180
13. Untighten the upper fixing bolts (2EA) of steering
column shaft and then remove the steering column
assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст