SsangYong Rexton. Service manual — part 619
SSANGYONG Y200
6E-12 STEERING COLUMN
5. Connect each wiring connector of steering column.
YAD6E230
YAD6E240
YAD6E250
6. Install the combination switch assembly in
steering column shaft.
7. Install the contact coil in steering column shaft
which the combination switch is installed.
Notice: When you adjust the neutral position of
contact coil, rotate the contact coil to C.W.
direction until it stops and then again rotate it by
2.9 ±0.2 to C.C.W. direction. Align the mark ( )
Which is marked in contact coil.
3. Tighten the floor bolt of steering column as
specified torque.
Installation Notice
4. Tighten the upper bolt of steering column shaft
as specified torque.
Installation Notice
Tightening Torque
20 - 25 N•m
(15 - 18 lb-ft)
Tightening Torque
20 - 25 N•m
(15 - 18 lb-ft)
YAD6E220
STEERING COLUMN 6E-13
SSANGYONG Y200
YAD6E270
YAD6E220
YAD6E280
9. Install the steering column cover and instrument
panel.
10. Install the fuse box in the panel, each cable and
switch. Insert the panel side cover.
Notice: The panel side cover should be inserted
to the inside of molding and then installed.
11. Install the steering wheel in order that it is aligned
to the assembly marting of column shaft.
Notice: Apply the grease to the shaft spline part
in order that the wheel is installed easily.
YAD6E260
8. Connect the fuel cut vacuum hose with the
connector.
Notice: The identification color is marked in fuel
cut vacuum hose.
Color
Green
Blue
Classification
Fuel Cut Vacuum Hose-Inlet
Fuel Cut Vacuum Hose-Outlet
SSANGYONG Y200
6E-14 STEERING COLUMN
YAD6E290
12. Before installing the horn pad in steering wheel,
first install each connector and then install the horn
pad.
Notice: When installing the pad, insert the safety
pin to the wheel hold and align the shaf end part
with the pad groove.
13. Tighten the left/right screw of steering wheel and
connect the negative terminal of battery.
STEERING COLUMN 6E-15
SSANGYONG Y200
1
UNIT REPAIR
STEERING GEAR BOX
Disassembly
1. Remove the steering column assembly from the
vehicle.
Notice: Be careful so that the steering column/
steering column shaft is not gotten the impact. If
being gotten the impact, in case of the frontal
collision, the plastic sleeve may be broken.
YAD6E300
YAD6E310
YAD6E330
YAD6E320
2. Remove the steering column shaft from the
steering column.
•
Remove the retainer ring.
•
Push the steering column shaft strongly
downward.
Assembly
1. Assemble in reverse order of disassembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст