SsangYong Rexton. Service manual — part 682
SSANGYONG Y200
9D-42 BODY ELECTRICAL
YAD9D870
YAD9D880
YAD9D890
YAD9D900
Power antenna and module
Power antenna
1. After separating the negative terminal, remove
lower quarter panel of seat in the passenger seat.
2. Remove fixing cover of power antenna.
3. Install the reverse order of removal.
Module of glass antenna
1. Remove the upper quarter panel.
2. Remove module of glass antenna.
•
Separate connector of glass antenna.
•
Separate jack of antenna.
•
Release bolt (2ea).
•
Separate connector of rear heating line.
•
Remove module of glass antenna.
3. After separating motor connector of power
antenna, and then release fixing nut of motor.
4. Remove power antenna assembly.
BODY ELECTRICAL 9D-43
SSANGYONG Y200
YAD9D910
YAD9D920
YAD9D930
CD Changer
1. Remove the negative terminal of battery and
AUDIO.
2. Separate cable of CD changer from the AUDIO.
5. After releasing bracket fixing bolt of changer of
CD, remove changer of CD.
6. After Installing the reverse order of removal, check
unusual noise or state of operation.
3. Remove rear lower quarter panel in the driver seat.
4. Remove cable from the changer of CD.
SSANGYONG Y200
9D-44 BODY ELECTRICAL
WIPER AND WASHER
General Description
Wiper system of sensing rain
Summary
Wiper motor of musso and korando is controlled by
stics. In the case of this, time of operation of wiper is
controlled by stics, driver should control time which is
drived of stics. But wiper system of rexton is sensing
quantity of rain by the unit of sensing rain which is
installed on the upper center of windshield, this unit is
controlling operation of wiper, low and high speed
according to quantity of rain.
Diagram Of System
Multifunction switch
Control wiper mode and ON/OFF
Quantity of rain
Unit of sensing rain
Unit of sensing is sensing quantity of rain,
according to quantity of rain, this unit is controlling
operation of wiper,low and high speed.
Wiper motor
BODY ELECTRICAL 9D-45
SSANGYONG Y200
;;;;;;
;;;;;;
;;;;;;;
;;;;;;;
Mode of operation
Wiper control system consist of OFF, MIST, LOW,
WASHER, plus AUTO mode, if turn to the position of
AUTO, rain sensor is sensing drop of rain, and then, is
controliing time of operation, speed of operation with
LOW, HIGH.
YAD9D950
1. Unit of sensing rain is sensing by the LED and
the diode of photo.
2. As infrared ray is emitting from LED, diode of
photo which is reflected by drop of rain is sensing
the quantity of rain.
3. Unit of sensing rain is correcting itself, so
regardless of transmitting of windshield, this unit
is constantly sensing rain.
4. This unit is sensing the area between the LED and
diode of photo.
Principle of Rain Sensor
YAD9D940
Wave which is transmitted reflects and reinput
(Wave drop of rain is contacting, loss
happen by transmitting electronic wave)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст