SsangYong Rexton. Service manual — part 485
PROPELLER SHAFT 3C-5
SSANGYONG Y200
PROPELLER SHAFT ASSEMBLY
YAD3C030
1 Front Axle
2 Bolt
3 Front Propeller Shaft
4 Bolt
5 Transfer Case
6 Bolt
7 Rear Propeller Shaft
8 Bolt
9 Rear Axle
SSANGYONG Y200
3C-6 PROPELLER SHAFT
ON-VEHICLE SERVICE
PROPELLER SHAFT ASSEMBLY
Removal
1. Do alignment marks before removing the propeller
shaft.
YAD3C040
YAD3C060
YAD3C050
2. Remove the flange yoke fixing bolt/nut that
connects the front propeller shaft axle side with
transfer case.
Pull out the front propeller shaft assembly.
3. Remove the flange yoke bolt/nut of transfer case
side in rear propeller shaft.
MAINTENANCE AND REPAIR
PROPELLER SHAFT 3C-7
SSANGYONG Y200
5. Remove the rear axle housing flange yoke bolts/
nuts of rear propeller shaft.
Pull out the rear propeller shaft assembly.
YAD3C090
YAD3C100
YAD3C080
Installation
1. Check the disassembled parts visually.
2. Align the assembly mark of each propeller shaft.
3. Install the front propeller shaft.
Installation Notice
Tightening Torque
81 - 89 N•m
(60 - 66 lb-ft)
4. Set up the rear propeller shaft between the
transmission and axle housing. Tighten the center
bearing manually.
Installation Notice
Tightening Torque
80 - 95 N•m
(59 - 70 lb-ft)
YAD3C070
4. Remove the fixing bolt of middle bearing (center).
SSANGYONG Y200
3C-8 PROPELLER SHAFT
YAD3C110
5. Align the rear propeller shaft to the assembly mark.
Tighten the bolts/nuts and then the center bearing
bolts.
Installation Notice
Tightening Torque
70 - 80 N•m
(52 - 59 lb-ft)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст