SsangYong Rexton. Service manual — part 486
PROPELLER SHAFT 3C-9
SSANGYONG Y200
YAD3C130
YAD3C140
YAD3C120
UNIT REPAIR
PROPELLER SHAFT
Disassembly
1. Mark the assembly mark and remove the propeller
shaft.
2. Do alignment mark before separating the spider.
3. Remove the snap ring using the snap ring plier.
4. Slightly tapping the yoke shoulder using a brass
hammer, remove the bearing.
Remove the remaining bearing in the same way.
YAD3C150
5. If it is not removed, clamp the welding part of
yoke in the vise.
SSANGYONG Y200
3C-10 PROPELLER SHAFT
YAD3C190
3. Clearance between the spider and bearing
Inspection
1. Visual Check
Check the disassembled parts for wear and crack.
Replace them if necessary.
2. Spider outer diameter
YAD3C160
YAD3C170
YAD3C180
6. Disassemble the universal joint parts.
As axles move up and down, universal joints allow
drive angle to change without bending of propeller
shaft.
7. Remove the center bearing bracket and center
bearing using the special tool.
standard
Limit
16.647 mm
16.668 mm
standard
Limit
0.03 ~ 0.098 mm
0.25 mm
PROPELLER SHAFT 3C-11
SSANGYONG Y200
YAD3C200
YAD3C210
4. Propeller Shaft runout
Using a dial gauge, measure propeller shaft runout
by turning the shaft. If runout exceeds limit, adjust
the propeller shaft using a press or replace it.
Limit
0.4 mm
5. Universal joint starting torque
6. Major cause of vibration
•
Separation of balance weights
•
Excessive runout of the propeller shaft
•
Using the general bolts
•
Excessive wear of universal joint
•
Sticks in sleeve joint
•
Vibration is caused by front & rear universal
joint, pinion angle change and is generally broke
out when the vehicle speed is around 60 ~
100km/h.
Specified Value
3 ~ 8 kg•cm
YAD3C220
Assembly
Clean the disassembled parts and replace then if
damaged.
1. Align the alignment marks of the yoke and
assemble the spider, bearing and snap ring.
SSANGYONG Y200
3C-12 PROPELLER SHAFT
YAD3C240
YAD3C250
3. Install the bearing cap to the yoke and insert the
spider. Install the opposite cap by tapping with a
plastic hammer.
4. Assembly the center bearing to the rear propeller
shaft.
YAD3C230
2. Apply the grease to the inner of bearing cap of
needle roller bearing and assemble the needle
roller.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст