SsangYong Rexton. Service manual — part 496
SSANGYONG Y200
4A-14 BRAKE SYSTEM
YAD4A230
YAD4A240
YAD4A250
REPAIR INSTRUCTIONS
ON-VEHICLE SERVICE
VACUUM HOSE
Removal Procedure
1. Disconnect the vacuum hose from the brake
booster.
2. Disconnect the vacuum hose from the vacuum
pump.
3. Remove the vacuum hose with the vacuum hose
bracket.
BRAKE SYSTEM 4A-15
SSANGYONG Y200
YAD4A260
YAD4A270
YAD4A280
YAD4A290
Installation Procedure
1. Install the vacuum hose between the vacuum
pump and the power booster (Diesel Engine).
Tightening Torque
2. Install the vacuum hose between the vacuum
pump and the power booster. (Gasoline Engine)
Tightening Torque
Bracket Mounting
Bolt
Union Bolt to Vacuum
Pump
35 - 45 N•m
(26 - 33 lb-ft)
35 - 45 N•m
(26 - 33 lb-ft)
Bracket Mounting
Bolt
Union Bolt to Vacuum
Pump
35 - 45 N•m
(26 - 33 lb-ft)
35 - 45 N•m
(26 - 33 lb-ft)
BRAKE OIL LEVEL SWITCH
Removal & Installation Procedure
1. Disconnect the brake fluid level switch connector.
2. Disconnect the switch wiring connector.
3. Disconnect the switch from the brake oil tank.
SSANGYONG Y200
4A-16 BRAKE SYSTEM
4. Installation should follow the removal procedure
in the reverse order.
YAD4A300
YAD4A310
YAD4A320
YAD4A330
BRAKE FLUID RESERVOIR
Removal & Installation Procedure
1. Remove the reservoir tank cap and drain the brake
fluid completely.
2. Remove the brake reservoir tank using the driver.
Notice: Note that pulling the reservoir tank out
excessively result in damage of the tank on
removal.
3. Remove the grommet from the master cylinder.
4. Installation should follow the removal procedure
in the reverse order.
Notice:
•
Lubricate the new brake fluid reservoir seals with
clean brake fluid.
•
After the installation, bleed the brake system.
BRAKE SYSTEM 4A-17
SSANGYONG Y200
YAD4A340
YAD4A350
YAD4A360
YAD4A370
3. Remove the master cylinder.
•
Retain the master cylinder in the vice and
remove the retainer ring from the master cylinder
using the snap ring plier.
2. Loosen the mounting nut of the master cylinder
and remove the master cylinder from the power
booster.
MASTER CYLINDER
Removal Procedure
1. Disconnect the brake lines from the master
cylinder.
Notice: The brake fluid may damage paintwork, if
spillage onto paintwork, wash with cold water
immediately.
•
Remove the 1st piston and 2nd piston assembly
from the master cylinder assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст