SsangYong Rexton. Service manual — part 388
DIESEL ENGINE MECHANICAL 1B3-127
SSANGYONG Y200
OIL SPRAY NOZZLE
YAD1BHZ0
1 Fitting Sleeve
2 Oil Spray Nozzle
3 Combination Bolt . . . . ... 10 N•m (89 lb-in)
a Oil Duct
Removal & Installation Procedure
1. Remove oil pan or crankshaft.
2. Loose the bolt and then remove the nozzle.
Installation Notice
Tightening Torque
10 N•m (89 lb-in)
3. Installation should follow the removal procedure
in the reverse order.
YAD1BJ00
SSANGYONG Y200
1B3-128 DIESEL ENGINE MECHANICAL
OIL PUMP
Preceding Work:
Removal of oil pan
YAD1BJ10
1 Oil Pump
2 Bolt . . . . . . . . . . ... 25 N•m (18 lb-ft)
3 Sprocket
4 Poston
5 Pressure Spring
6 Guide Pin
7 Screw Plug . . . . . . . ... 50 N•m (37 lb-ft)
8 Bolt . . . . . . . . . . ... 25 N•m (18 lb-ft)
YAD1BJ20
Removal & Installation Procedure
1. Removae the bolt from the oil pump drive sprocket
and separate the gear and the oil pump drive
chain.
Installation Notice
Tightening Torque
25 N•m (18 lb-ft)
DIESEL ENGINE MECHANICAL 1B3-129
SSANGYONG Y200
YAD1BJ30
2. Remove the oil pump mounting bolts and oil pump.
Installation Notice
3. Unscrew the screw plug and remove the relief
valve.
Installation Notice
4. Installation should follow the removal procedure
in the reverse order.
Tightening Torque
50 N•m (37 lb-ft)
Tightening Torque
25 N•m (18 lb-ft)
SSANGYONG Y200
1B3-130 DIESEL ENGINE MECHANICAL
UNIT REPAIR
MILLING OF PRECHAMBER SEALING SURFACE
YAD1BJ40
1 Drift
2 Sleeve
3 Milling Cutter
4 Counter Sink (Special Tool - 601 589 00 66 00)
5 Cylinder Head
Notice: The prechamber sealing surface may only be remachined once with the cylinder head fitted. It is essential
to adhere to the specified projection ‘C’ of the prechamber of 7.6 - 8.1mm.
This ensures that the required clearance exists between prechamber and piston crown with the piston in TDC. For
this reason, spacer rings should be inserted on remachined sealing surfaces.
Thickness of spacers
0.3, 0.6, 1.0 mm
If a spacer ring is already fitted, or a marking is made on the cylinder head, the cylinder head must be removed
and size ‘C’ measured if further remachining is necessary on a prechamber sealing surface.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст