SsangYong Rexton. Service manual — part 572
MANUAL TRANSMISSION 5B-45
SSANGYONG Y200
YAD5B1C0
INSPECTION OF COMPONENTS
Inspection Procedure
1. Clean all parts with solvent and dry them with
compressed air. Check the following parts for
cracks and damaged sealing surfaces.
•
Case
•
Extension housing
•
Shift Cover
•
Input bearing retainer
•
Counter shaft rear bearing retainer
2. Check the parts which support bearings and shafts
for excessive wear and replace them if necessary.
YAD5B1D0
YAD5B1B0
3. Check the bearing surfaces of the following parts ;
•
Input shaft
•
Main shaft and its gears
•
Counter shaft and 5th drive gear
4. Check the reverse idler shaft and its gears.
Notice: Replace excessive wear parts and do not
file on the hardened surface and precision ground.
SSANGYONG Y200
5B-46 MANUAL TRANSMISSION
5. Check the shift mechanism parts as follows :
•
Wear of the shift shaft.
•
Wear of the detent/guide plate and offset lever.
YAD5B1E0
YAD5B1F0
YAD5B1H0
YAD5B1G0
6. Check worn edges on the following parts :
•
Selector arm.
•
Interlock plate.
•
Selector plates for the 1-2 and 3-4 shift forks.
•
5-R shift lever and the rollers on the reverse
fork and the 5th shift rail/fork.
7. Check worn mating surfaces on the following parts :
•
1-2 shift fork, pads and synchronizer sleeve.
•
3-4 shift fork, pads and synchronizer sleeve.
•
5th shift rail/fork pads and synchronizer sleeve.
•
Reverse fork and reverse idler gear sleeve.
MANUAL TRANSMISSION 5B-47
SSANGYONG Y200
YAD5B1K0
YAD5B1M0
8. Check the following Bearing for excessive war:
•
Crankshaft pilot bushing for the front of the input
shaft.
•
Clutch release bearing.
•
Input shaft bearing.
•
Main shaft pilot bearing rollers.
•
Main shaft thrust Bearing and its surfaces.
•
Speed gear roller bearing on the main shaft.
•
Main shaft rear bearing.
•
Counter shaft front and rear bearings.
YAD5B1L0
YAD5B1J0
9. Check the gear tooth surfaces of all gear sets.
10. Check the reverse gear set surfaces. Check the
surfaces of gear teeth for excessive wear, pitting,
scoring and spalling and replace if necessary.
SSANGYONG Y200
5B-48 MANUAL TRANSMISSION
11. Take apart the three synchronizer assemblies and
check :
•
The 1-2 synchronizer.
YAD5B1N0
YAD5B1P0
YAD5B1R0
YAD5B1Q0
•
The 5th blocking ring.
12. Check the fit between the hub and sleeve of each
synchronizer
•
Excessively tight or loose hub-to-sleeve fit.
•
Wear of the cone clutch surfaces of brass
blocking rings and gears.
13. Measure the clearance between the blocking ring
and the speed gear
•
New 1-2 blocking ring : 0.87 - 1.4mm
•
New 3-4 blocking ring : 0.88 - 1.5mm
Notice: Excessive wear of the blocking ring or the
speed gear cone surface will cause shift block-
out gear clash.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст