SsangYong Rexton. Service manual — part 666
BODY EXTERIOR 9C-37
SSANGYONG Y200
YAD9C0P0
YAD9C0Q0
YAD9C0R0
YAD9C0S0
FRONT DOOR WINDOW
Removal and Installation
1. Remove seal and door trim.
2. After adjusting glass left and right, fit gap with
quarter glass.
Torque of Tightening
9 - 10 N•m
(44 - 52 lb-ft)
Check the Deflection
As tail gate is pushed from the external, not to occur
the deflection, adjust overlap.
Standard
18 mm
Adjust Gap of Fitting
(mm)
Section
Gap
C
5
A
11
B
5
D
5.7
E
4.2
SSANGYONG Y200
9C-38 BODY EXTERIOR
YAD9C0T0
YAD9C0U0
YAD9C0V0
YAD9C0W0
2. Remove glass of front door.
1) Release fixing screw (2 ea) of glass, at this
time, position of plate of regulator carrier should
be position of installation.
2) Remove glass.
Notice: If glass interfere to the body, damage of
section of body painting may happen, so glass
should not interfere body.
3. Install reverse order of removal.
Fixing Bolt of Glass
3 N•m (26 lb-ft)
Notice: If water of soap spread on contacting
section between glass run and glass, so that, can
be installed easily.
FRONT DOOR GLASS RUN AND
REGULATOR
Removal and Installation
1. Remove door trim, seal, and window glass.
2. Remove door glass run from door .
3. After releasing fixing nut of door regulator, and
then remove motor connector of power window.
BODY EXTERIOR 9C-39
SSANGYONG Y200
YAD9C0X0
YAD9C0Y0
YAD9C0Z0
YAD9C1A0
REAR WINDOW
Removal and Installation
1. Remove external weather strip of door window
2. Remove front garnish of rear door.
4. Remove door regulator assembly.
Notice: After separating door glass run and
regulator, remove and install them .
5. As door glass run is installed, water of soap spead
on section of glass run so door glass run can be
installed easily.
6. Install reverse order of removal.
Fixing Nut of Regulator
8 N•m (26 lb-ft)
SSANGYONG Y200
9C-40 BODY EXTERIOR
YAD9C1B0
YAD9C1C0
YAD9C1D0
YAD9C1E0
3. Remove seal and door trim.
4. Remove rear door glass.
1) Release screw (move up carrier plate of
regulator).
2) Extract glass upwards.
Notice: If glass interfere to the body, damage of
section of body painting may happen, so glass
should not interfere body.
5. Install reverse order of removal.
Fixing Nut of Glass
3 N•m (26 lb-ft)
Notice: As door glass run is installed, water of
soap spead on section of glass run so door glass
run can be installed easily.
REAR GLASS RUN/ REGULATOR/
CHANNEL
1. Remove door trim, seal, and glass
2. Remove glass run.
•
Pull door glass run internally, and then extract
glass run.
Notice: As door glass run is installed, water of
soap spead on section of glass run so door glass
run can be installed easily.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст