Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 80
4.
CAUTION: If brake fluid is spilt on the paintwork, the affected
area must be immediately washed down with cold water.
• NOTE: Install suitable blanking plugs.
• NOTE: Right-hand drive shown, left-hand drive similar.
Disconnect the clutch master cylinder supply line.
5.
CAUTION: If brake fluid is spilt on the paintwork, the affected
area must be immediately washed down with cold water.
• NOTE: Install suitable blanking plugs.
• NOTE: Right-hand drive shown, left-hand drive similar.
Disconnect the clutch slave cylinder supply line from the clutch master
cylinder.
Release the retaining clip to disconnect the line.
Right-hand drive vehicles
6. Remove the brake pedal and bracket retaining nuts.
Vehicles without driver lower air bag
7. Remove the driver side instrument panel lower trim panel.
Vehicles with driver lower air bag
8. Remove the driver lower air bag.
For additional information, refer to:
Driver Lower Air Bag Module
(501-20B Supplemental Restraint System, Removal and Installation).
All vehicles
9. Remove the support panel.
Left-hand drive vehicles
10. Position the front wheels in a straight ahead position and centralize
the steering wheel.
Lock in position and remove the ignition key.
11. Detach the steering column.
Remove and discard the steering column lower retaining bolt.
All vehicles
12. Remove the accelerator pedal.
For additional information, refer to:
Accelerator Pedal
(310-02
Acceleration Control, Removal and Installation).
13. Detach the wiring harness.
14. Remove the anti-collapse bracket clevis pin.
1. Remove the anti-collapse bracket clevis pin retaining clip.
2. Remove the anti-collapse bracket clevis pin.
15. Reposition the anti-collapse bracket.
Right-hand drive vehicles
16. Remove the brake booster push rod retaining nut.
17. Remove the accelerator pedal mount bracket.
Left-hand drive vehicles
18. Remove the brake booster push rod retaining clip.
1. Release the brake booster push rod retaining clip.
2. Remove the brake booster push rod retaining clip.
19. Remove the accelerator pedal mount bracket.
20. Remove the brake pedal and bracket retaining nuts.
All vehicles
21. Remove the brake pedal and bracket retaining nuts.
22. NOTE: Right-hand drive shown, left-hand drive similar.
Remove the brake pedal and bracket.
Disconnect the electrical connector.
Installation
All vehicles
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст