Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 79
9. NOTE: Remove and discard the O-ring seal at the rear of the brake
master cylinder.
Remove the brake master cylinder and reservoir.
1. Remove the brake master cylinder retaining nuts.
2. Remove the brake master cylinder and reservoir.
Installation
All vehicles
1. NOTE: Install a new O-ring seal to the rear of the brake master
cylinder.
Install the brake master cylinder and reservoir.
1. Install the brake master cylinder and reservoir.
2. Install the brake master cylinder retaining nuts.
1. Tighten to 20 Nm.
2. Connect the brake fluid supply tubes.
Tighten to 15 Nm.
3. Connect the coolant low level warning indicator electrical connector.
4. Attach the coolant expansion tank.
1. Reposition the coolant expansion tank.
2. Turn the coolant expansion tank clockwise.
3. Install the coolant expansion tank retaining bolt.
Vehicles with manual transmission
5. Attach the clutch master cylinder feed hose.
All vehicles
6. Attach the brake booster vacuum hose.
7. Connect the brake fluid low level warning indicator electrical connector.
8. Fill the brake fluid reservoir.
9. Bleed the brake system. For additional information, refer to Section
206-00 Brake System - General Information
.
10. Install the brake fluid reservoir filler cap.
Published: 11-May-2011
Hydraulic Brake Actuation - Brake Pedal and Bracket
Removal and Installation
Removal
Vehicles with manual transmission
1.
W ARNING: Brake fluid contains polyglycol ethers and polyglycols.
Avoid contact with the eyes. Wash hands thoroughly after handling. If
brake fluid contacts the eyes, flush the eyes for 15 minutes with cold
water. Get medical attention immediately if irritation persists. If taken
internally, drink water and induce vomiting. Get medical attention
immediately. Failure to follow these instructions may result in personal
injury.
CAUTION: If brake fluid is spilt on the paintwork, the affected area
must be immediately washed down with cold water.
• NOTE: Make sure the filler cap does not become contaminated.
Remove the brake fluid reservoir filler cap.
2.
CAUTION: If brake fluid is spilt on the paintwork, the affected
area must be immediately washed down with cold water.
Using a suitable suction device, drain the brake fluid reservoir.
3. NOTE: Vehicles with 2.5L or 3.0L engine only.
Detach the engine wiring harness.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст