Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 413
8. NOTE: Shown from the under side of the vehicle for clarity.
Press the red locking tab to secure the position of the shift cable.
9. Place the transmission selector into the neutral position.
10. NOTE: Shown from the under side of the vehicle for clarity.
Detach the red locking tab on the selector cable.
11. NOTE: Shown from the under side of the vehicle for clarity.
Attach the selector cable to the ball pin on the gearbox mass damper.
12. NOTE: Shown from the under side of the vehicle for clarity.
Press the red locking tab to secure the position of the selector cable.
13. Remove the special tool.
14. Attach the gearshift lever surround.
15. Check for correct operation of gear controls.
16. Connect the reverse lamp switch electrical connector.
17. Install the transaxle mount bracket.
Tighten to 80 Nm.
Vehicles with diesel engine
18. Install the clutch master cylinder to clutch slave cylinder high pressure
pipe support.
19. Install the charge air cooler pipe retaining nut.
All except vehicles with diesel engine
20. Install the clutch master cylinder to clutch slave cylinder high pressure
pipe support bracket.
All vehicles
21. Attach the clutch master cylinder to clutch slave cylinder high pressure
pipe to the support bracket.
22. Install the transaxle support insulator.
Tighten to 47 Nm.
23. Install the transaxle mount bracket securing nut.
Tighten to 133 Nm.
Vehicles with diesel engine
24. Remove the special tool.
25. Remove the special tool.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст