Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 506
8. Install the A/C clutch.
Install the A/C clutch retaining nut.
9. Using the special tool, tighten the A/C clutch retaining nut.
Tighten to 26 Nm.
10. Measure and adjust the A/C clutch air gap by removing or installing
A/C clutch shims.
A/C clutch air gap to be set between 0.35 mm (0.014 in) and 0.75
mm (0.03 in).
11. Install the A/C compressor.
For additional information, refer to:
Air Conditioning (A/C) Compressor -
2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
(412-03 Air
Conditioning, Removal and Installation).
Published: 11-May-2011
Air Conditioning - Condenser Core
Removal and Installation
Removal
1. Reclaim the refrigerant. For additional information, refer to Section
412-00 Climate Control System - General Information
.
2. Remove the front bumper cover. For additional information, refer to
Section
501-19 Bumpers
.
3. NOTE: Seal the tube and the condenser with plugs
Detach the air conditioning tube.
Remove and discard the O-ring seal.
4. NOTE: Seal the tube and the condenser with plugs
Detach the air conditioning tube.
Remove and discard the O-ring seal.
5. Detach the condenser.
Remove the retaining bolts.
Right-hand side shown, left-hand side similar.
6. Lower the vehicle.
7. Remove the condenser.
Installation
1. To install, reverse the removal procedure.
2. Tighten 7 Nm.
3. NOTE: Coat the refrigerant line O-ring seals in clean refrigerant oil prior
to installation.
Install a new O-ring seal.
4. NOTE: Coat the refrigerant line O-ring seals in clean refrigerant oil prior
to installation.
Install a new O-ring seal.
Published: 11-May-2011
Air Conditioning - Evaporator Core
Removal and Installation
Removal
1. Remove the in vehicle cross beam and evaporator core housing. For
additional information, refer to Section
412-02A Heating and
Ventilation
Section
412-02B Auxiliary Heating
.
2. Detach the blower motor housing from the in vehicle cross beam..
3. Remove the evaporator core housing from the in vehicle cross beam.
4. Remove the air inlet blend door actuator.
Remove the retaining screws.
Disconnect the electrical connector.
5. Remove the rubber seal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст