Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 511
5. Remove the sunload sensor.
Installation
1. To install, reverse the removal procedure.
Published: 11-May-2011
Control Components - Temperature Blend Door Actuator
Removal and Installation
Removal
1. Remove the lower vent.
1. Detach the bulb holder.
2. Remove the lower vent.
2. Disconnect the temperature blend door actuator electrical connector.
3. Remove the temperature blend door actuator.
Remove the retaining screws.
Installation
1. To install, reverse the removal procedure.
Published: 11-May-2011
Instrument Cluster and Panel Illumination - Instrument Cluster and Panel Illumination
Diagnosis and Testing
The complexity of the electronics involved with the instrument cluster preclude the use of workshop general electrical test equipment.
Therefore, reference should be made to the Jaguar Approved Diagnostic System for detailed instructions on testing the instrument cluster.
The Jaguar Approved Diagnostic System tests and analyses, in detail, all functions of the instrument cluster.
Where a fault involving the instrument cluster is indicated by the Jaguar Approved Diagnostic System, some basic diagnostic methods may
be necessary to confirm that connections are good and that the wiring is not damaged, before installing new components.
1. Verify the customer concern by operating the system.
1.
2. Visually inspect for obvious signs of mechanical or electrical damage.
2.
Visual Inspection Chart
Mechanical
Electrical
Fluid level(s)
Accessory installations
Bulb(s)/LED(s)
Fuse(s)
Damaged or corroded wiring harness
Electrical connector(s)
Engine/engine compartment or underbody components
Instrument cluster
3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next
step.
3.
4. If the cause is not visually evident, verify the sympton and refer to the Jaguar Approved Diagnostic System.
4.
Published: 11-May-2011
Instrument Cluster - Instrument Cluster
Description and Operation
Vehicles W ith 2.0L, 2.5L And 3.0L Engines
Item
Part Number
Description
1
—
Engine temperature gauge
2
—
Left hand direction indicator
3
—
Door ajar warning
4
—
Low exterior temperature warning
5
—
Tachometer
6
—
Powertrain malfunction
7
—
Engine malfunction
8
—
Front fog lamps
9
—
Main beam
10
—
Side (Parking) lamps
11
—
Rear fog lamps
12
—
Speedometer
13
—
Overspeed warning (Gulf coast countries only)
14
—
Right hand direction indicator
15
—
Fuel level gauge
16
—
Low fuel remainder lamp
17
—
Parking/Low brake fluid indicator/EBD system failure
18
—
Safety belt indicator
19
—
Trip odometer
20
—
Cruise (speed) control activated
21
—
Low washer fluid level
22
—
Airbag warning indicator
23
—
Traction control/Dynamic Stability Control (DSC) indicator
24
—
Anti-lock Brake System (ABS) warning indicator
25
—
Charge warning indicator
26
—
Oil pressure warning indicator
27
—
High engine temperature warning
Vehicles W ith 2.0L, 2.5L And 3.0L Engines
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст