Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 25
Published: 11-May-2011
Suspension System - General Information - Rear Toe Adjustment
General Procedures
• NOTE: The checking and subsequent adjustment of the rear toe setting should be carried out on a flat surface and in accordance with the
manufactures instructions for the wheel alignment equipment used.
1. NOTE: Final tightening of the rear suspension components should be
carried out when the vehicle weight is on the road wheels.
Using suitable four wheel alignment equipment, check the toe setting.
2. Raise and support the vehicle.
For additional information, refer to Section
100-02 Jacking and Lifting
.
3. NOTE: Left-hand shown, right-hand similar.
Loosen the rear lower arm cam bolt nuts.
4. Rotate the the cam bolts equal amounts, in either a clockwise or a
counterclockwise direction, to adjust the toe setting.
5.
CAUTION: The final tightening of the suspension components
should be carried out with the vehicle on its wheels. Failure to follow this
instruction may result in damage to the vehicle.
• NOTE: Left-hand shown, right-hand similar.
Tighten the rear lower arm cam bolt nuts.
6. Lower the vehicle.
Bounce the vehicle to make sure that the suspension is in its
normal resting position.
7. NOTE: Left-hand shown, right-hand similar.
Tighten the rear lower arm cam bolt nuts.
Tighten to 115 Nm.
Published: 11-May-2011
Suspension System - General Information - Wheel Bearing Inspection
General Procedures
1. Raise and support the vehicle. For additional information, refer to
Section
100-02 Jacking and Lifting
.
2. NOTE: Make sure the wheel rotates freely and the brake pads are
retracted sufficiently to allow movement of the wheel and tire.
Firmly hold the tire at the top and bottom and move the wheel inward
and outward while lifting the weight of the wheel and tire off the wheel
bearing.
3. If the wheel and tire is loose on the wheel hub assembly or does not
rotate freely, install a new front or rear wheel bearing as necessary. For
additional information, refer to Section
204-01 Front Suspension
or
Section
204-02 Rear Suspension
.
Published: 11-May-2011
Front Suspension -
Torque Specifications
Description
Nm
lb-ft
lb-in
Lower arm front retaining bolt
A
A
A
Lower arm rear retaining nut and bolt
A
A
A
Lower arm ball joint retaining nut and bolt
83
61
-
Stabilizer bar to link bar retaining nuts
48
35
-
Stabilizer bar to subframe retaining bolts
48
35
-
Strut top mount retaining nuts
25
18
-
Subframe front mount retaining bolts
142
105
-
Subframe rear mount retaining bolts
142
105
-
Subframe reinforcement plate retaining bolts (M8)
35
26
-
Subframe reinforcement plate retaining bolts (M10)
70
52
-
Engine roll restrictor to engine retaining bolt
80
59
-
W heel knuckle pinch bolt
85
63
-
W heel hub retaining nut
270
200
-
Steering column lower retaining bolt
25
18
-
A = refer to the procedure for the correct torque sequence
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст