Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 144
12. Attach the coolant pipe.
13. Attach the coolant hose.
14. Install the air filter retaining bracket.
15. Attach the generator wiring harness.
16. Install the air filter intake pipe.
17. Install the cooling fan motor and shroud. For additional information,
refer to Section
303-03A Engine Cooling
Section
303-03B Engine Cooling
.
18. Fill and bleed the cooling system. For additional information, refer to
Section
303-03A Engine Cooling
Section
303-03B Engine Cooling
.
Published: 11-May-2011
Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Flexplate
In-vehicle Repair
Removal
1. Remove the automatic transmission. For additional information, refer
toSection
307-01A Automatic Transmission/Transaxle
Section
307-01B
Automatic Transmission/Transaxle
.
2. NOTE: Prevent the flexplate from rotating.
Remove the flexplate.
Installation
1. NOTE: Make sure the crankshaft and flexplate mating faces are clean
before installation.
• NOTE: The flexplate will only locate in one position.
• NOTE: Tighten the retaining bolts working diagonally.
Install the flexplate.
Prevent the flexplate from rotating.
Tighten to 80 Nm.
2. Install the automatic transmission. For additional information, refer
toSection
307-01A Automatic Transmission/Transaxle
Section
307-01B
Automatic Transmission/Transaxle
.
Published: 11-May-2011
Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Exhaust Manifold
RH
In-vehicle Repair
Removal
1. Remove the three way catalytic converter (TWC). For additional
information, refer to Section
309-00 Exhaust System
.
2. Disconnect the heated oxygen sensor (HO2S) electrical connector.
3. Using a suitable tool remove the HO2S.
4. Remove the exhaust manifold.
Remove and discard the exhaust manifold gasket.
Installation
1. Install the exhaust manifold.
Install the new exhaust manifold gasket.
Complete the tightening sequence.
Tighten to 20 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст