Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 640
8. Remove the tape from the inner edge of the roof panel.
9. Remove the protective sheet and the protective board from the parcel
shelf.
10. Remove the protective tape from around the windshield glass
aperture.
11.
CAUTION: Do not connect the electrical connector for at least 1
hour after installation of the windshield glass. Failure to follow these
instructions may result in damage to the windshield glass adhesive.
Connect the electrical connector.
12.
CAUTION: Do not connect the electrical connector for at least 1
hour after installation of the windshield glass. Failure to follow these
instructions may result in damage to the windshield glass adhesive.
Connect the electrical connector.
13.
CAUTION: Do not connect the electrical connectors for at least 1
hour after installation of the windshield glass. Failure to follow these
instructions may result in damage to the windshield glass adhesive.
Connect the electrical connectors.
14.
CAUTION: Do not connect the electrical connectors for at least 1
hour after installation of the windshield glass. Failure to follow these
instructions may result in damage to the windshield glass adhesive.
Connect the electrical connectors.
15. Attach the parcel shelf trim panel.
16. Install the rear seat backrest latch covers.
17. Attach the seat belt reel trim panels.
18. Install the high level stop lamp. For additional information, refer to
Section
417-01 Exterior Lighting
.
19.
CAUTION: Make sure the windshield glass adhesive is set before
removing the protective tape.
Remove the protective tape from the top of the windshield glass.
Published: 11-May-2011
Glass, Frames and Mechanisms - Window Control Switch
Removal and Installation
Removal
1. Remove the front door trim panel. For additional information, refer to
Section
501-05 Interior Trim and Ornamentation
.
2. Remove the window control switch.
Installation
1. To install, reverse the removal procedure.
Published: 11-May-2011
Glass, Frames and Mechanisms - Windshield Glass Using Cheese Wire
Removal and Installation
Removal
1. Remove the sun visors.
For additional information, refer to Section
501-05 Interior Trim and
Ornamentation
.
2. Remove the cowl vent screen cover.
For additional information, refer to Section
501-02 Front End Body
Panels
.
3. Remove the interior mirror.
For additional information, refer to Section
501-09 Rear View Mirrors
.
4. NOTE: Left-hand shown, right-hand similar.
Disconnect the heated windshield glass electrical connectors.
5. Remove the A-pillar exterior trim.
6. Apply suitable protective tape around the windshield glass aperture to
protect the paintwork.
7. Place a suitable protective sheet over the fascia and place a protective
board over the sheet.
8. Apply suitable protective tape to the leading inner edge of the roof
panel.
9. Prepare the cheese wire and the cutting handle.
Position the cutting handle central tube fully upwards in the
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст