Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 209

78. Using the special tools, remove the drive halfshaft.

79. Remove and discard the drive halfshaft snap ring.

80. Remove the drive halfshaft.

81. NOTE: Discard the O-ring seals.

• NOTE: Cap the exposed ports.

Disconnect the power steering lines.

82. Detach the wiring harness.

83. Remove the engine roll restrictor.

84.

CAUTION: Do not support the engine and transaxle assembly

directly on the oil pan. Failure to follow this instruction may cause damage
to the component.

Using a suitable hydraulic lift, remove the engine and transmission from
the subframe and place to a suitable working area.

85. Remove the charge air cooler pipe retaining nut.

86. Detach the reverse lamp switch wiring harness retaining clip.

87. Remove the charge air cooler pipe.

88. Disconnect the reverse lamp switch electrical connector.

89. Remove the vacuum regulator solenoid valve.

1. Disconnect the electrical connectors.

2. Detach the vacuum hoses.

3. Remove the vacuum regulator solenoid valve.

90. Detach the starter motor wiring harness.

91. Remove the starter motor wiring harness retaining bracket.

92. Disconnect the starter motor wiring harness electrical connector.

93. Detach the starter motor wiring harness.

1. Disconnect the starter motor electrical connector.

2. Disconnect the starter motor solenoid electrical connector.

94. Remove the starter motor.

95. Disconnect the crankshaft sensor electrical connector.