Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 210
96. Remove the transmission upper retaining bolts.
97. Remove the transmission right-hand retaining bolts.
98.
CAUTION: Do not support the engine and transaxle assembly
directly on the oil pan. Failure to follow this instruction may cause damage
to the component.
Remove the engine assembly from the transmission assembly.
Published: 11-May-2011
Engine - 2.0L Duratorq-TDCi/2.2L Duratorq-TDCi (110kW/150PS) - Puma -
Engine2.2L Duratorq-TDCi (110kW/150PS) - Puma
Removal
Special Tool(s)
Remover/Installer, Cooling Hose Clamp
303-397 (24-003)
Ball joint splitter
204-192
Wheel hub puller
205-491
Adaptor nuts
205-491-01
Forcing screw
204-269
Powertrain assembly jack
HTJ1200-02
Engine lifting eye
303-1067
5 Point Security Torx Bit
418-535
Removal
All vehicles
1. Remove and discard the steering column lower retaining bolt.
2. Remove the steering column coupling.
3. Remove the battery tray.
For additional information, refer to:
Battery Tray
(414-01 Battery,
Mounting and Cables, Removal and Installation).
4. Recover the air conditioning refrigerant.
For additional information, refer to:
Air Conditioning (A/C) System
Recovery, Evacuation and Charging
(412-00 Climate Control System -
General Information, General Procedures).
5. Drain the cooling system.
For additional information, refer to:
Cooling System Draining, Filling and
Bleeding
(303-03B Engine Cooling - 2.0L Duratorq-TDCi/2.2L
Duratorq-TDCi (110kW /150PS) - Puma, General Procedures).
6. Remove the exhaust flexible pipe.
For additional information, refer to:
Exhaust Flexible Pipe - 2.0L
Duratorq-TDCi/2.2L Duratorq-TDCi (110kW/150PS) - Puma
(309-00
Exhaust System, Removal and Installation).
Vehicles without auxiliary heating
7. Disconnect the heater hoses from the heater core.
Vehicles with electric booster heater
8. Detach the electric booster heater electrical connector from the
subframe retaining tang.
9. Detach the coolant hoses from the retaining clips.
10. Detach the coolant hose.
Disconnect the coolant hose.
Vehicles with fuel fired booster heater
11. Disconnect the fuel fired booster heater electrical connector from the
subframe retaining tang.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст