Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 134
4. Install the CKP.
Tighten to 10 Nm.
5. Connect the CKP electrical connector.
6. Install the splash shield.
7. Install the wheel and tire. For additional information, refer to Section
204-04 W heels and Tires
.
Published: 11-May-2011
Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Crankshaft Rear
Seal
In-vehicle Repair
Special Tool(s)
Crankshaft Rear Seal Remover
303-566
Crankshaft Rear Seal Installer
303-178
Crankshaft Rear Seal Installer Adapter Bolts
303-384
Crankshaft Rear Seal Installer Draw Bolts
303-102
Removal
Vehicles With Manual Transmission
1. Remove the flywheel. For additional information, refer to
Flywheel
—Manual Transmission
.
Vehicles With Automatic Transmission
2. Remove the flexplate. For additional information, refer to
Flexplate
—Automatic Transmission
.
All Vehicles
3.
CAUTION: Avoid scratching or damaging the oil seal sealing
surfaces on the crankshaft and cylinder block.
Using the special tool, remove the crankshaft rear main oil seal.
Installation
All Vehicles
1. Clean and inspect the crankshaft rear oil seal sealing surfaces.
2. NOTE: Use oil WSE-M2C908-A or equivalent meeting Jaguar
specification.
Lubricate the seal lip with oil.
3. NOTE: Alternate bolt tightening to correctly seat the crankshaft rear oil
seal until it is flush with the cylinder block.
Using the special tool, install the crankshaft rear oil seal.
Vehicles With Manual Transmission
4. Install the flywheel. For additional information, refer to
Flywheel
—Manual Transmission
.
Vehicles With Automatic Transmission
5. Install the flexplate. For additional information, refer to
Flexplate
—Automatic Transmission
.
Published: 11-May-2011
Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Cylinder Head LH
In-vehicle Repair
Removal
Vehicles with 2.5L or 3.0L engine
1. Disconnect the engine coolant temperature (ECT) and fuel temperature
sensor (FTS) electrical connectors.
2. Disconnect the electrical connector.
3. Detach fuel sensor vacuum line.
Vehicles with 2.0L engine
4. Disconnect the coolant temperature (ECT) electrical connector.
All vehicles
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст