Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 133
Published: 11-May-2011
Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Crankshaft Front
Seal
In-vehicle Repair
Special Tool(s)
Crankshaft Front Seal Remover
303-700
Crankshaft Front Seal Installer
303-542
Crankshaft Damper Installer
303-102
Removal
1. Remove the crankshaft vibration damper. For additional information,
refer to
Crankshaft Pulley
.
2. Using the special tool, remove the crankshaft front oil seal.
Installation
1.
CAUTION: Make sure the seal and the tool are approximately
parallel to the front of the engine.
• NOTE: Lubricate the seal lip with oil W SE-M2C908-A or equivalent
meeting Jaguar specification.
Using the special tool, install the crankshaft front oil seal.
2. Install the crankshaft vibration damper. For additional information, refer
to
Crankshaft Pulley
.
Published: 11-May-2011
Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Crankshaft Pulley
In-vehicle Repair
Special Tool(s)
Wrench strap-universal
303-D055
Crankshaft Damper Remover
303-D121
Thrust Pad
303-D121-01
Crankshaft Damper Installer Draw Bolt
303-102
Crankshaft Damper Installer
303-335/2
Accessory Belt Detensioner
303-703
Removal
1. Remove the wheel and tire. For additional information, refer to Section
204-04 W heels and Tires
.
2. Remove the splash shield.
3. Disconnect the crankshaft position sensor (CKP) electrical connector.
4. Remove the CKP sensor.
5. Detach the accessory drivebelt.
1. Using the special tool, rotate the belt tensioner counter
clockwise.
2. Detach the accessory drivebelt.
6. Using the special tool, remove the crankshaft vibration damper retaining
bolt.
Remove and discard the crankshaft vibration damper retaining bolt.
7. Install the special tool.
8. Using the special tools, remove the crankshaft vibration damper.
Installation
1. NOTE: Coat the crankshaft damper keyway with silicone gasket sealant
WSE-M4G323-A6 or equivalent meeting Jaguar specification.
Using the special tool, install the crankshaft vibration damper.
2. Using the special tool, tighten the crankshaft vibration damper retaining
bolt.
Install a new crankshaft vibration damper retaining bolt.
1. Complete the tightening sequence.
2. Stage 1: Torque to 120 Nm.
3. Stage 2: Loosen the bolt (minimum 1 turn).
4. Stage 3: Torque to 50 Nm.
5. Stage 4: Angle Torque to 90°.
3. Attach the accessory drivebelt.
1. Using the special tool, rotate the belt tensioner counter-
clockwise.
2. Attach the accessory drivebelt.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст