Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 86
22. Install the brake pedal cross-shaft support bracket retaining bolt.
Tighten to 25 Nm.
All except vehicles with diesel engine
23. Connect the ECM electrical connector.
Using special tool 418-535, tighten to 5 Nm.
Vehicles with diesel engine
24. Attach the engine wiring harness retaining clip.
25. Connect the ECM electrical connector.
Tighten to 5 Nm.
26. Attach the engine wiring harness electrical connector.
27. Attach the engine wiring harness retaining clip.
28. Connect the engine wiring harness electrical connector.
Tighten to 10 Nm.
29. NOTE: Remove the blanking plugs from the fuel pump fuel supply and
return line male and female connectors.
Connect the fuel pump fuel supply and return lines.
For additional information, refer to:
Quick Release Coupling - Push
Connect
(310-00 Fuel System - General Information, General
Procedures).
All vehicles
30. NOTE: Remove the blanking plugs.
Connect the A/C refrigerant line.
Install new O-ring seals.
31. Install the A/C refrigerant line retaining clip.
32. NOTE: Remove the blanking plugs.
Connect the A/C refrigerant line.
Install new O-ring seals.
33. Install the refrigerant line retaining clip.
Vehicles with 2.0L engine
34. Install the intake manifold.
For additional information, refer to:
Intake Manifold
(303-01A Engine -
2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27, In-vehicle
Repair).
All except vehicles with diesel engine
35. Install the evaporative emission canister purge valve retaining
bracket.
Install the retaining nuts.
Tighten to 5 Nm.
36. Attach the wiring harness to the retaining bracket.
37. Connect the lower fuel vapor hose to the evaporative emission
canister purge valve.
38. Connect the evaporator solenoid electrical connector.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст