Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 87
39. Attach the oxygen sensor electrical connectors.
40. Connect the upper fuel vapor hose to the evaporative emission
canister purge valve.
All vehicles
41. Install the brake booster.
For additional information, refer to:
Brake Booster - RHD AWD/RHD FWD
(206-07 Power Brake Actuation, Removal and Installation).
Vehicles with diesel particulate filter
42. NOTE: Note the orientation of the DPF differential pressure
high-pressure and low-pressure hoses and make sure they are installed in
the same position.
Connect the DPF differential pressure sensor high-pressure and
low-pressure hoses.
43. Connect the DPF differential pressure sensor electrical connector.
44. Attach the DPF differential pressure sensor retaining bracket.
Install the retaining nuts.
Tighten to 5 Nm.
45. Attach the wiring harness.
46.
CAUTION: Install the retaining clip to the original position.
Failure to follow this instruction may result in damage to the vehicle.
Attach the the DPF high-pressure and low-pressure hoses.
47. Install the air cleaner outlet pipe.
For additional information, refer to:
Air Cleaner Outlet Pipe
(303-12B
Intake Air Distribution and Filtering - 2.0L Duratorq-TDCi/2.2L
Duratorq-TDCi (110kW /150PS) - Puma, Removal and Installation).
All vehicles
48. Recharge the A/C refrigerant.
For additional information, refer to:
Air Conditioning (A/C) System
Recovery, Evacuation and Charging
(412-00 Climate Control System -
General Information, General Procedures).
49. Connect the battery ground cable.
For additional information, refer to:
Battery Connect
(414-01 Battery,
Mounting and Cables, General Procedures).
Published: 11-May-2011
Power Brake Actuation -
Torque Specifications
Description
Nm
lb-ft
lb-in
Brake booster retaining nuts
25
18
-
Brake master cylinder retaining nuts
25
18
-
Coolant expansion tank retaining bolt
3
-
27
Speed control module retaining bolt - Vehicles with 2.0L engine
4
-
35
Vacuum pump retaining nuts - Vehicles with 2.0L engine
10
-
89
Vacuum pump retaining bolts - Vehicles with diesel engine
23
17
-
Published: 11-May-2011
Power Brake Actuation - Brake Booster
Description and Operation
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands after handling. If brake fluid
contacts the eyes, flush the eyes for 15 minutes with cold running water. Get medical attention if irritation persists. If taken internally,
drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
Item
Part Number
Description
1
—
Brake fluid reservoir filler cap
2
—
Brake fluid reservoir
3
—
Brake fluid low level warning indicator
4
—
Brake master cylinder
5
—
Brake booster
6
—
Brake booster vacuum hose grommet
The diaphragm type power brake booster:
is self contained.
is mounted on the engine side of the bulkhead.
uses engine intake manifold vacuum, vacuum pump and atmospheric pressure for its assistance.
is connected to a manifold vacuum hose with a built in non return valve.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст