Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 493
19. Disconnect the electrical connectors.
20. Detach the wiring harness.
21. Detach the wiring harness.
22. Detach the wiring harness.
Remove the earth lead retaining bolt.
Detach the wiring harness.
23. Using a suitable tool cut the bonding on the in vehicle cross beam.
Left-hand side shown, right-hand side similar.
24. Detach the center of the in vehicle cross beam.
25. Remove the in vehicle cross beam retaining bolts.
Left-hand side shown, right-hand side similar.
26. Remove the in vehicle cross beam and the evaporator core housing.
Installation
1. NOTE: Remove the PU bonding from the in vehicle cross beam.
• NOTE: Clean the in vehicle cross beam locator and the vehicle body
locating pegs with a solvent wipe, part number WSKM14J251-A1.
• NOTE: Apply the PU bonding, part number W SKM2G379-A1 to the in
vehicle cross beam locating pegs.
To install, reverse the removal procedure.
2. Tighten to 25 Nm.
Left-hand side shown, right-hand side similar.
3. Tighten to 25 Nm.
Published: 11-May-2011
Heating and Ventilation - Heater Core
Removal and Installation
Removal
1. NOTE: If a leak is suspected, the heater core must be leak tested in the
vehicle before removal. For additional information, refer to Section
412-00
Climate Control System - General Information
.
Drain the cooling system. For additional information, refer to Section
303-03A Engine Cooling
Section
303-03B Engine Cooling
.
2. Disconnect the drain tube from the heater core.
3. Disconnect the heater hose from the heater core.
4. Disconnect the heater hose from the heater core.
5. Remove the center console. For additional information, refer to Section
501-12 Instrument Panel and Console
.
6. Position the heater core air duct up.
1. Remove the heater core air duct retaining screw.
2. Position the heater core air duct up.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст